- ThumbDV wont work with BlueDV
Re: ThumbDV wont work with BlueDV
toggle quoted messageShow quoted text
I guess my question is not worth a reply. Device only works in a
2.0 port or earlier.
On 2/18/2021 08:09 PM, W6JJ - Bruce
Ok - downloaded the test.exe and ran it - plugged in the com
port - then baud rate - then it ran and closed immediately . . .
. was not able to see anything - so I am guessing its bad for
that to happen.
appear as a COM port when you plug it in?
is very old, you may need to switch to 230400 baud. (Turn
serial off, goto Menu -> Setup then under AMBE block).
is a test exe in the files section of this forum to verify
If you try to access it at the wrong baud rate, you may
have to unplug and replug it and try again at the right
baud rate depending on your computer's USB hardware.
On Thu, Feb 18, 2021 at
4:30 PM W6JJ - Bruce <W6JJ@...
I have an older ThumbDV and tried to set it up to work
with the BlueDV software so many have said works. Mine
does not - even though it says DV3000U on the ThumbDV - so
I am "GUESSING" that means it's using the Ambe 3000 chip?
I have no idea - but would guess YES. Am I wrong? Please
Join firstname.lastname@example.org to automatically receive all group messages.