I may still have an older version around. Aren't they available online in the archived area? I will look when I get back to my PC. 73 de AF6BY Jeff

Hi all is there anywhere i can get older versions of BlueDV for windows, looking for any version that has Vox. 73 Dave

I'm a new-to-DMR user and have BlueDV installed and working with a DVmega stick. I am connected to Brandmeister DMR talkgroups and can make contacts just fine now. I notice that when others speak, I

Are you using these instructions https://github.com/nwdigitalradio/ambeserver-install/blob/master/README.md

Derek, This should work with compatible AMBE devices from other manufacturers. We do not provide technical support for other manufacturers, if you run into difficulties, contact the manufacturer. You

Looking at the instructions, it reads that it is for ThumbDV. I am using the DVmega version, I assume it will also work? I also have another question, not sure if this is the place for it but here

Absolutely brilliant. Couldn't be easier.

The Wiki is updated.

A new AMBEserver install process is available at https://github.com/nwdigitalradio/ambeserver-install

https://github.com/nwdigitalradio/ambeserver-install/blob/master/README.md (this is a new install procedure, it has been tested - send feedback if you try it.)

Thank you John That was my best guess, but just wanted to be sure.

/etc/systemd/system Is the correct location for user created/installed service files.

Thanks for a great tutorial. However I do have a question. In the section about using WinSCP it says to copy the ambeserver@... file to lib/systemd/system However in the following section regarding

A pair of dongles can be used on the channel that needs the transcoding, so you need a pair for however many channels you have that do transcoding. There are some cards out there (not sure about

You would only need 52 chips if you anticipated all 26 modules being used simultaneously. That would likely never happen. Three is four pairs is typically quite sufficient. If you only want to

So the reflectors have a total of 25 modules. That means I’d need 52 of them? assuming each module a, b, c, is a channel?

You need 2 dongles per channel. Ambe software is in the xlx download. Get Outlook for Android

Hi all, I’m totally new with this, so I hope you will forgive my lack of knowledge, and/or what is needed with regards to my goals, and objectives in this post. I’ve just recently setup an xlx

Good morning Patrick: I am using an OpenSpot 1 and it serves as a bridge between my Fusion repeater (conencted to room 28104 on my HRI-200) and my YSF CHARC reflector on whick Peanut is connected.

Hi Patrick, I'd be interested in more detail about how your setup "WIRES x ishappening between a Yaesu HRI-200 and an Allstar node in analogmode" is happening. In regard to Alain's query I host an