SO how do I work around this?

Buster does support xlx and xrf as well as the others. Peter WA7FUS

Ron, Buster does support XRF and should support XLX reflectors, since they use the same protocol. (i am currently connected to XRF012-A) The problem is more likely that Buster can't resolve the IP

I wish I could, because I think that would work really well. unfortunately sometimes having two screen-readers and a VM don’t play nice. I’d love to reach out to the author of this app, and see

It does not support XLX or XRF. I see you are on a Mac platform, so this may not be helpful but there is "BlueDV" for Windows or Linux available that I believe supports XLX. You might be able to run

Folks, I've just started using Buster which is available in the Mac app store, and works with THumb DV, and the Zum AMBE server. When I check the "about this app" section, I see that it is made by

BM uses your self-care login from their website to connect to the masters now. -=-=-=-=-=-=-=-=- 73, Gwen, NG3P

BlueDV runs on my MIcrosoft Surface 64-bit, no reason it shouldn't run on yours. It's AMBE-3000 and AMBE-3003 the 3000 is used in the ThumbDV™ and similar devices. The 3003 is rare, but is

I am still a little confused on the setup but watched many videos and all similar. What is the difference between the Ambe 300 and 303 and for BM what is the password, if different than the one that

i HAD EVERYTHING WORKING FINE AND NOW i CAN TURN ON SERIAL, BUT CANNOT CONNECT TO D-STAR OR FUSION. i AM SURE IT IS A SETTING PROBLEM, BUT DON'T KNOW WHERE TO GO.......HELP PLEASE..... MIKE

Check Buster preferences settings for correct audio in / audio out settings. Check Mac System Preferences for the same and for volume adjustment. Also, on the Buster main screen there is a slider

Down load free program Telegram and after setting up go to Dvmegabot group. Tell them what you are doing and someone should be able to help you. I'm away from home right now out camping so a bit

I AM ABLE TO CONNECT TO REFLECTORS, BUT NO AUDIO OUT OR IN FROM THE REFLECTORS. ON AUDIO PREFERENCES SELECTED AUDIO IN & OUT BUT NO AUDIO AT ALL ON BOTH WAYS. ANY ADVICE OR RECOMMENDATIONS?

Thank you that did work. Thank You Brian Childs KN4PGY

Brian Change your dmr type to “BM” and use your security password if you’re planning to use the Brandmeister network. Also did you activate the hotspot security on the brandmeister site?

Currently setting up an AMBE3000. I can get the DSTAR to work but not the DMR part. I have setup a hotspot security thru Brandmeister since I already run both a DVMEGA hotspot in my truck and a DVMEGA

John, First, let me say thank you for your reply. Second I was under the understanding that each ThumbDV from NW-Digital gives you two channels each so I was expecting to see 4 channels, not just

The DV3000/PiDV. I was planning on doing a short segment about AMBE Server on the RPi, since it's been a while since I've done anything with AMBE on Linux. I'm going to demonstrate with the ThumbDV

So what device are you trying to access?

Almost there...(it was a bad SD card) however, I'm running into an error when I run 'sudo systemctl status ambeserver@ttyAMA0' ambeserver@... - AMBEserver Daemon Loaded: loaded