Yes I have; for my Direwolf " project ". I currently have Direwolf running on a BBB and am looking to move that to a Pi and " speed up " from 1k2 to 9k6; I have a spare URIx, hence the reason for

Glad to hear. Have you looked at the UDRC in lieu of the URI?

Hello, I am pleased to report I am now up and running with CompassLinux ( GUI version ) and ThumbDV on the RP13. Thanks for the help and suggestions. My next move will be to CompassLinux ( no GUI )

OK, John, will check it out!...Thanks Bruce WB5NOQ

It does run on Win 10 Start here http://nwdigitalradio.com/thumbdv-and-dv3000-resource-page/ -- John D. Hays K7VE PO Box 1223, Edmonds, WA 98020-1223

Purchased the Thumb-DV and trying to figure if it will work with Win 10. Starting from scratch, and need some help! Bruce WB5NOQ

Thanks John.. I was thinking that I needed some type of sound card. I hadn’t thought of splitting dummy repeater from the gateway. Thanks again.

Problem solved; I have an error with my ThumbDV. I tried WinDV - it didn't recognise my ThumbDV; I tried Buster - it didn't recognise my ThumbDV; I have contacted my supplier. Thanks for the

Tom, It took a minute to figure out what you were trying to do. There is no 2-way soundcard on the Raspberry Pi, unless you add one, e.g. a USB headset or sound FOB. If you are coming in from another

I'm in the process of setting up the following and I needs some gaps in my understanding filled. Here's the high level view: 1. I have a Raspberry PI 3 with a DV3000. 2. I loaded the

Please use the instructions at https://nw-digital-radio.groups.io/g/ambe/wiki/Installing-AMBEserver-on-a-Raspberry-Pi-and-ThumbDV%E2%84%A2 -- the Github instructions are out of date, though you could

Hello Geoff, Thanks for the pointers, I have gone through the download/setup etc with a fresh card and I am still experiencing a problem. It'll be something simple I imagine, perhaps because I am

From your error log, you are running at 230400 baud. If your ThumbDV is new, it runs at 460800. Make sure it is at /dev/ttyUSB0 and modify the configuration as per

Ian- I had quite the time with a Pi3 and DV3000 board. This set of directions worked for me, and also worked for my friend I sent them to, KI7SI. Best of luck, let me know how it goes. 73, Geoff,

Hello, While I try and figure out were I have gone wrong I thought I'd post this just in case someone else has experienced it. As you can see the ambeserver starts but falls over a few seconds

Thanks - got it. -- Mobile: (941) 888-4519 Home : (941) 677-3914 Ham : KM4VIG ~TomC.

Northwest digital radio site look under products. Don WB5EKU

Looking for the information on the Jumpers to be used to utilize the UART on the PiDV if anyone has this information or a link to it it would be appreciated. The PiDV™ is designed to use the

Ok, I thought that was only when I was running them from a different computer on the network. I'll give it a try again.

When AMBEserver is running, you do not select a serial port, you select DV3000 network -- https://nw-digital-radio.groups.io/g/ambe/wiki/AMBEserver-Addendum#DummyRepeater-for-Windows-or-Linux --