I have attached a screen snip of my settings screen. I am using a slightly different password. Perhaps the same will work for you? My password has a “zero” instead of a “one”. If that

I am using a ThumbDV with BlueDV. I have configured BlueDV for BM type DMR and entered my DMR ID in DMR hotspot and simple. DMR Master 3102 passw1rd. I am unable to get the DMR button at the lower

Thanks guys.....Your feedback and responses were awesome!! Mission accomplished!!!....73 Dev, 9Y4DG-- “Your chances of success in any undertaking can always be measured by your belief in yourself"

A standard convention in Unix/Linux is to provide a simple usage message, by using an -h or --help flag to a command. e.g. ambeserver -h will show you: Usage: AMBEserver [-d] [-r] [-s speed] [-p port]

Sorry a typo /usr/local/sbin/ambeserver -d -p 24999 -i /dev/ttyUSB0 -s 460800 -- 73's *********************************** CT1JIB / Jorge Santos ***********************************

Hi all, You can use switch "p" to change port number, exemp: usr/local/sbin/ambeserver -d -i -p 24999 /dev/ttyUSB0 -s 460800 Hope this help -- 73's *********************************** CT1JIB /

Hi Dev, as you remember before you compile (with make and make install) you had edit the ambeserver.c file with a editor (as root) to change in it the baudrate ( maybe you have), on one

There are command line switches to set the port and device.

Thank you Frank for your very prompt response.. It seems as though you might be using Compass Linux. Unfortunately, I'm using Raspian Stretch., so there is no opendv folder and neither am I seeing any

Dev I’m running multiple servers also and I did the following on the PI server: pico /etc/opendv/ambeserver-ttyUSB0.conf Changed the UDP port to 18307 Did UDP port forwarding on the router for

Good day, The AMBEServer defaults to port 2460. I would like to run multiple servers simultaneously. Of course, they can't all use port 2460 concurrently. So the question is how

Thanks Jorge...will certainly do...73 de Dev, 9Y4DG

Thanks Gwen...73 Dev, 9Y4DG..

Sorry, Dev, we're singing the same song as before...you didn't say what you wanted clearly enough. I didn't know you even HAD BlueDV. You only mentioned Peanut. Jorge is right -- you'll have to

Hi Dev, If you are admin of XLX299 contact David (info@...) and ask him to routing your ambeserver to xlx299 R. -- 73's *********************************** CT1JIB / Jorge

Thank you for your suggestion, but I already use BlueDV. I would like to link XLX 299 Module R to Peanut so that anyone using Peanut would have access to that reflector. Thanks again...Dev, 9Y4DG

Well then, just pop over to the play store and get BlueDV AMBE. That's the correct client app, not Peanut.

Yes Sir...a ThumbDV is connected to the AMBE Server... That's how I can work DMR and DSTAR from anywhere. But I agree with you that I should have mentioned that in the original post. Thank you for

Do you have an AMBE device connected to that Pi, like a ThumbDV? AMBEServer doesn't work by itself, I don't think. It needs an AMBE chip in a piece of hardware to do the coding and decoding. Peanut

Good day, Does any one know how the steps to get XLX 299 R on Peanut??? I already have a Raspbery Pi 3B+ running AMBE Server and it has its own hostname and IP address which can