Problem solved; I have an error with my ThumbDV. I tried WinDV - it didn't recognise my ThumbDV; I tried Buster - it didn't recognise my ThumbDV; I have contacted my supplier. Thanks for the

Thanks John.. I was thinking that I needed some type of sound card. I hadn’t thought of splitting dummy repeater from the gateway. Thanks again.

Purchased the Thumb-DV and trying to figure if it will work with Win 10. Starting from scratch, and need some help! Bruce WB5NOQ

It does run on Win 10 Start here http://nwdigitalradio.com/thumbdv-and-dv3000-resource-page/ -- John D. Hays K7VE PO Box 1223, Edmonds, WA 98020-1223

OK, John, will check it out!...Thanks Bruce WB5NOQ

Hello, I am pleased to report I am now up and running with CompassLinux ( GUI version ) and ThumbDV on the RP13. Thanks for the help and suggestions. My next move will be to CompassLinux ( no GUI )

Glad to hear. Have you looked at the UDRC in lieu of the URI?

Yes I have; for my Direwolf " project ". I currently have Direwolf running on a BBB and am looking to move that to a Pi and " speed up " from 1k2 to 9k6; I have a spare URIx, hence the reason for

Thought I'd share this; Now that my ThumbDV is up and running and I'm getting good audio reports I thought I would " experiment " with some Baofeng radios. ( I like them because you can tear them to

Hi Ian, Cool experiment. DummyRepeater should be able to be keyed using a GPIO line (I would have to dig through the code to see which one), in which case if you can detect squelch in the Baofeng and

Hello John, I had a wire from pin 1 ( cos ) on the 8 legged chip in the 888 connected but it held the tx on, maybe I need to invert it ?? I think pin 3 on the Pi3 GPIO can be used as well. What

John, There should be a site or two online that has this information, as I'm aware of a few people that use the BF-888 UHF radio for AllStar Link node radios. I can look for them.and post the links

So I have been running this on a raspberry pi one. That burned up a few weeks ago. I had to move the board to the pi 3. I have bluetooth turned off. It is raspbian headless. I can not get ambeserver

Hi Ryan, If the python script can read the device and you have installed the AMBEserver -- apply the instructions at https://nw-digital-radio.groups.io/g/ambe/wiki/AMBEserver-Addendum -- John D.

Any ideas for solving an error that shows when executing the thumbtest.exe file ? See attached screenshot . Andy K3UK

Hi Andy, Make sure your ThumbDV is at COM3 (I am assuming that from the 3 you typed in), you can do this by observing Device Manager while plugging and unplugging. Then try COM3 as the input rather

Gee, like the old days. I remember some old packet radio issues where the solution was "com 3 " rather than "3" after a Com prompt. i will give that a try. Thanks Andy K3UK

Hi all I am having a problem with the Dv Node for windows 1.5.8 preview3. When I start it up in windows 10 it runs for about 5 seconds then stops. Windows then puts up the report "WinDv not

George, This is probably a problem with WinDV, which is supported by DUTCH*Star -- NW Digital Radio manufactures the hardware, but software support comes from the authors. You can pull down

$20 off the regular price - visit: http://nwdigitalradio.com/product/thumbdv/ A great stocking stuffer for your ham friends.