No I didn't use the tool because I'd been using this thumb TV for at least 3 years on my Acer laptop and nothing had changed when I plugged it into the new laptop. The factory remains there are no com

Clay Assume you used the test tool for the thumb dv http://nwdigitalradio.com/thumbdv-and-dv3000-resource-page/ Art N2AJO

You have to update you password

You are welcome. I am glad it worked.

Thanks, Greg. I set a password and all is good. 73, Bob, KN4HH

The requirement of BM hotspot password?

After months of proper operation, the DMR mode of BlueDV has quit functioning. I am using Brandmeister and DMR Master 3102. I tried 3101, 3102, and 3103 and no connection. I tried using DMRPLUS and

It is not registering when you plug it in to USB. Is there anyway around this?

Ryan, It's pretty rare to have either a ThumbDV™ or PiDV™ fail. Have you run the test program (in files, the .exe for Windows or the Python program on Linux) and what were the results? What

Have you ever seen the ThumbDV just quit working? It was working during a converstion. It just quit in midstream. I have tried it on three different computers. It is doing nothing. My PiDV did the

Thanks guys, I seem to have all your suggested bases covered at this stage. I was wondering is this Portable AMBE Server using the same distro of Debian as NW does? I don't know enough about

I cannot answer for that specific product, since it is not a NW Digital Radio product like the ThumbDV™ However a couple of data points: The AMBEserver (generic) software is port and IP address

HI I've been using the same system for a few years. I can tell you that I have made some soft and hardware changes to the master which improves the latency a little when you are on the go (auto) as a

I run my AMBEServer on a Raspberry Pi, with the ThumbDV on a powered hub. I have a port forwarded to Dyndns so I can access it from anywhere using my phone or any other internet-connected machine.

hi, I have a portable ambe server https://reflectorloversclub.jimdofree.com/shop/ and am trying to accertain if moving the default port (2465) to match local ambeservers (2462) would effect the

Have you run the ThumbTest.exe from https://nw-digital-radio.groups.io/g/ambe/files ??? The ThumbDV™ appears to the operating system and applications as a simple serial device. There is no user

Tim, These are my (redacted) settings for BlueDV for Windows. Where I have filled in "YOURCALL", you should put in your callsign. Where I have filled in "DMR_ID" in three places, you should put in

Tim, Have a look at these 2 links. I'm wondering if the driver install isn't quite right. I know these instructions are for the XLX utility, but the driver install is probably identical. I also

baud rate of the Thumbdv is not a common baud rate it is 460800. try that in the software for the ambe server

I have tried the different baud rates and it does not seem to have an effect. The COM ports are correct it usually defaults to COM 6. Looks like the software is just not communicating with the AMBE