Do you have multiple AMBE devices plugged in? BTW, this is a software question that should be directed to the software group behind ambed. -- John D. Hays Kingston, WA K7VE

Just tried that with the same result, then i changed my ip address in the run file to my actual home network ip still showing Zero ?

Hello, What I did to my servers, if I get this result is, I unplug the ambe and plug it back, then ./run. Try that.

I have installed AMBEd on my Raspberry Pi3 but whenever i ./run i get "Codec interfaces initialized successfully : 0 channels available" so what am i doing wrong ? 73 John Mi0AAZ.

I verified that AMBEserver will build on Buster Raspbian, I don't have a PiDV to test with at the moment.-- John D. Hays Kingston, WA K7VE

Here are short instructions. From https://nw-digital-radio.groups.io/g/ambe/wiki/AMBEserver-Addendum#Quick-Build-on-Linux Quick Build on Linux If you cannot find an AMBEserver package for your

You probably need to build AMBEserver it is not on the standard repositories.

Thanks John, I really appreciate your assistance. The PIDV is definitely installed correctly on the Raspberry Pi, starting at PIN 1. I always start with a fresh install of the latest version of

You need to take a step wise approach to debug: 1. Make sure the HAT is properly seated. Orient it so that it is sitting on pins 1-26, here is an illustration on a 40 pin GPIO Raspberry Pi Use a

Mike, I tried with the Compass distro and got nowhere but I might try it again now that I'm aware of the serial port issues. Colin Colin G. MacArthur B.A., LL.B.

John, I followed the instructions for enabling the mini UART serial port and I disabled the serial console. I modified the AMBESERVER_FLAGS in /etc/opendv/ambeserver-ttyS0.conf to AMBESERVER_FLAGS="-s

OK. So first thing is to make sure the PiDV is properly seated on the pins. Here is information on using the serial port from the GPIO (turn off console to it)

The dv3000 which is now the PiDV as I understand. Colin Colin G. MacArthur B.A., LL.B.

I read the original and the 2 replies. I just got mine working locally but have not enabled outside connections yet. I struggled with getting mine working for a week of tries. I saw the reference

Are you using a PiDV™ or ThumbDV™ the errors look like you are trying a PiDV™ -- John D. Hays Kingston, WA K7VE

Not an issue for me but thanks. Colin Colin G. MacArthur B.A., LL.B.

Be advised there are some issues with Buster on Catalina that Anna is looking into. Bryan K7UDR

https://nw-digital-radio.groups.io/g/ambe/message/703 That always works for me. I just use/do it on raspbian. But follows those directions. I have not been able to do it from the directions you

Ladies and gents, HELP!! Before I pull out the remaining few strands of hair I have left, for the love of God, can someone please tell me what I'm doing wrong? I initially attempted to install my

Hi - Has anyone tried to use a ThumbDV with its AMBE firmware to feed digital data to a radio's TNC input or to modulate a radio's audio? I have an IC-7000, which has a 9600 data input and, like