Purely as an exercise I have XLX running on a BeagleBoneBlack and today I updated my Macbook with the resulting one-way audio. A few minutes testing identified my problem and a workaround. Regards, Ia

I have Buster 1.2.3 and I experienced the same one-way effect. In my case the cure I found is to issue a connect, for example, to DCS600 A instead of XLX600 A. A connection to XLX defaults to Dextra c

Marco, There is a message, five messages back, that may provide you with some help. Regards, Ian.. link to message

Здравствуйте, Я не знаю Windows, возможно, вам придется изменить на 460800 в последовательном порту. С Уважением, Ян ..

Thank you John for your prompt response. My ThumbDV is the A model.. Regards, Ian..

I'm currently in the early stages of experimenting with my ThumbDV and xlx with an installation on Debian 9 x64 and I would like to confirm exactly what needs to be changed in my existing ThumbDV. Add

FYI, I currently use my ThumbDV and two Baofeng 888's on D_Star, audio reports are good and my pal who lives in the next street has used his IC706 for D_Star via my 888 while I am in control of my sta

Hello John, I had a wire from pin 1 ( cos ) on the 8 legged chip in the 888 connected but it held the tx on, maybe I need to invert it ?? I think pin 3 on the Pi3 GPIO can be used as well. What really

Thought I'd share this; Now that my ThumbDV is up and running and I'm getting good audio reports I thought I would " experiment " with some Baofeng radios. ( I like them because you can tear them to b

Yes I have; for my Direwolf " project ". I currently have Direwolf running on a BBB and am looking to move that to a Pi and " speed up " from 1k2 to 9k6; I have a spare URIx, hence the reason for usin

Hello, I am pleased to report I am now up and running with CompassLinux ( GUI version ) and ThumbDV on the RP13. Thanks for the help and suggestions. My next move will be to CompassLinux ( no GUI ) an

Problem solved; I have an error with my ThumbDV. I tried WinDV - it didn't recognise my ThumbDV; I tried Buster - it didn't recognise my ThumbDV; I have contacted my supplier. Thanks for the pointers

Hello Geoff, Thanks for the pointers, I have gone through the download/setup etc with a fresh card and I am still experiencing a problem. It'll be something simple I imagine, perhaps because I am only

Hello, While I try and figure out were I have gone wrong I thought I'd post this just in case someone else has experienced it. As you can see the ambeserver starts but falls over a few seconds later.