[Edited Message Follows]

Here, specifically is what I'm getting while following the "Testing AX.25" section of the "Verifying" step of Getting Started. I don't understand why these commands are not giving any response. Is the output of mheard different from the tail command for direwolf? The stuff up at the top is the output of the tail command.

Apr 13 16:37:12 ke7rgpi direwolf[325]: Digipeater MISION audio level = 11(12/6) [NONE] ::|||||:_
Apr 13 16:37:12 ke7rgpi direwolf[325]: [0.3] NB7O-11>APOT21,WA2WA,WIDE1,MISION*,WIDE2-1:/233726h4541.09N/11854.59Wk295/054/A=001605charging the batteries
Apr 13 16:37:12 ke7rgpi direwolf[325]: Position with time, truck, Open Track
Apr 13 16:37:12 ke7rgpi direwolf[325]: N 45 41.0900, W 118 54.5900, 62 MPH, course 295, alt 1605 ft
Apr 13 16:37:12 ke7rgpi direwolf[325]: charging the batteries
^C


pi@ke7rgpi:~ $ ax25-status
Status for direwolf.service: RUNNING and ENABLED
Status for ax25dev.service: RUNNING and ENABLED
Status for ax25dev.path: RUNNING and ENABLED
Status for ax25-mheardd.service: RUNNING and ENABLED
Status for ax25d.service: RUNNING and ENABLED
AX.25 device: ax0 successfully configured with ip: 192.168.255.2
AX.25 device: ax1 successfully configured with ip: 192.168.255.3


pi@ke7rgpi:~ $ netstat --ax25
Active AX.25 sockets
Dest Source Device State Vr/Vs Send-Q Recv-Q


pi@ke7rgpi:~ $ mheard
Callsign Port Packets Last Heard


pi@ke7rgpi:~ $