I followed these instructions https://www.realvnc.com/docs/raspberry-pi.html And it works fine on two UDRC-2's Robert/KF7VOP

Try using TightVNC. Works well on the configuration you have.

Well, shortly after posting this I was able to get realvnc to work. If anyone is interested I'll pass on the details

I cannot get realvnc to run on Compass. I've tried manually installing it but without success. Any suggestions? I'm running Compass on a RPI3 with full updates and upgrades John B AD7QQ

Hello Bob, It's here :- < https://nw-digital-radio.groups.io/g/ambe/wiki > in the messages. Regards, Ian..

Ian, where could I find your post about using PI3:Thumdv and Baofeng Bob AF9W

This is an experimental area, you are unlikely to find an image ready to go. You would load Compass Linux or Raspbian Jesse, then add application code, which may require compiling from source. There

Any help from yourselves who have do this already and suggestions of a good Raspberry Pi 2 or 3 image would be appreciated, initially the DMR to Analogue bridge sounds good for starters ? John.

There are a few applications. Use your PiDV in an AMBEserver.

Hello John, I guess it is possible; I have used my ThumbDV as a D_Star<> Analogue bridge. See my post about Pi3;ThumbDV and Baofeng.. Regards, Ian..

I have a PiDV which i purchased a number of years ago and was wondering if i could put it to use to create a bridge between lets say D-Star <-> DMR or from one of these modes to analogue FM ? 73 John

I think the question is, do you want to potentially violate the intellectual property rights (patents) behind the vocoders (e.g. mbelib probably violates those IP rights) vs using a licensed vocoder

i can decode such digital voice data with dsdplus (software decoder) i use hdsdr (sdrsoft) ... virtual audio cable (to route digital audio towards dsd) ... and the decoding software

Me to Dirk, I am interested in using the DVthumb on DMR. Any software to support it? 73, Barry K6ST https://twitter.com/barrybettman http://www.linkedin.com/in/barrybettman

https://nw-digital-radio.groups.io/g/ambe/topic/4044089#101 -- John D. Hays K7VE PO Box 1223, Edmonds, WA 98020-1223

Hello, Is it possible, to use the ThumbDV with SDR Software, like SDR#? Or can it be use, with the "Audio Virtual Cable" tool? I want to decode DMR, D-STAR, etc. with my SDR receiver and a SDR

If so please post you settings. Thanks, K4CAE - David Livingston

sudo systemctl disable dstarrepeaterd@1

OK I had the Deamon version of dstarrepeaterd running also so shutting off the GUI ones didn't let me see that. How can I stop the Deamon one from starting at boot. My Problem is I receive on my

Start Upsudo systemctl start dstarrepeaterd@1 If you want to see a GUI, run the commands:sudo systemctl stop dstarrepeaterd@1sudo dstarrepeater 1 The UDRC™ should now decode D-STAR signals