I messed up the file name. The extension should be .pcap (tcpdump formats the file appropriately for Wireshark to digest) Steve, N9VW

A suggestion if I may. The tcpdump command will generate a lot of data and it becomes problematic to capture it from the screen and/or the buffer will overrun and you will miss packets. I have

What version of the BETA image did you start from? head -n1 /var/log/udr_install.log What version of Raspbian did you start from? cat /etc/*version How big is your SD card? df -h I now recommend

There are a couple of possibilities. It is possible to configure Direwolf to gate traffic to the Internet. If you did NOT touch the direwolf.conf file then you are most likely OK since my scripts do

I would hold off, the latest release has been out less than a week. On the other hand, if you have second SD card of the same form factor, you can make a backup of your current system using the

Hi, The last time I did a 'sudo apt-get update; sudo apt-get upgrade', I bricked my system so had to re-do the overall setup. I would like to update my system, but I do not want to re-setup eerything

My Draws hat with Xastir is sending packets out over my wifi when I have it on. When I turn off my wifi it sends the packets out via a normal digipeater on the rf side. I found this out when a

Yep… good contact and you went “automagically” into my HRD logbook here. Not too shabby. There was a lot of nearby traffic so I was afraid it wouldn’t go through. Enjoy the DRAWS hat… I

Got you in the logs Jack! -15 both ways.

Here are my signal reports for today. Pretty good overall I'd say:

I ca post all the relevant menu configuration i'm using later tonight (PDT). I haven't modified much from the defaults, possibly which sideband to use (USB) in data mode,

I was looking at the menus last night and it was getting too late for me to spend much time on it. That's great info you got form Yaesu, i was thinking of doing the same today. Maybe you get to figure

Yes that definitely looks like a narrow filter on the 'data' setting. The calculation (which is also built into DRAWS™ Manager - http://localhost:8080 - https://www.youtube.com/watch?v=v5C3cWVVz_A )

Steve, Looks like you have a very narrow filter width defined in the radio? Can you open that up? KD4IZ Jack Spitznagel FM19oo

Alright, making progress left and right today. Turns out my input audio levels are too low. I get to decode some signals, but not all of what is out there. I'm currently getting about 2 or 3 signals

Dave, A short answer to your question. In your case with the ICOM products you are %100 correct in that most of the things you want to do are embedded in the radio. However, you

So that is really interesting. On my working setup I made a few contacts on 40m last night. This setup uses the radio in USB mode, not Data/Pkt. When I switch DRAWS to Data/Pkt I am able to transmit

You can do it either way, but if you're not using the DIN connector, you're not using the DRAWS.

I'm curious as to why we would need to use the miniconnector rather than just use the usb? That's a step backwards imho. I haven't tried the draws hat or image yet, but i can run my 7200 and fldigi

I'll have to dig around on this. To add some context to my comment - i've got a huge amount of interference around my home so just getting anything workable is a near miracle for me. I need to