All,
Thanks for your patience on this thread – the problem was not self-evident and I don’t understand why the following situation works for me. The solution was to comment out all references to port 1 – left channel in the direwolf.config file as shown below with changes in red.
What confuses me:
- Even if port 1 is not configured, when a radio is attached to the left port and turned on, Direwolf will not digipeat. Turn it off and it will digipeat from port 0.
- If the left channel port 1 references are all enabled, Direwolf will not digipeat on port 0 or port 1 regardless if the port 1 radio is turned on or off.
Jack – KD4IZ
----- Working direwolf.conf -----
ADEVICE plughw:CARD=udrc,DEV=0
ARATE 48000
ACHANNELS 1
#Port 0
CHANNEL 0
MYCALL KD4IZ-2
MODEM 1200
PTT GPIO 23
#Port 1
#CHANNEL 1
#MYCALL KD4IZ-3
#MODEM 9600
#PTT GPIO 12
AGWPORT 8000
KISSPORT 8001
TBEACON delay=1 sendto=0 every=10 overlay=S symbol="digi" power=5 height=20 gain=6 comment="DRAWS 0 1200" via=WIDE1-1,WIDE2-1
#TBEACON delay=1 sendto=1 every=10 overlay=S symbol="digi" power=5 height=20 gain=6 comment="DRAWS 1 9600" via=WIDE1-1,WIDE2-1
DIGIPEAT 0 0 ^WIDE[3-7]-[1-7]$|^TEST$ ^WIDE[12]-[12]$ TRACE
#DIGIPEAT 1 1 ^WIDE[3-7]-[1-7]$|^TEST$ ^WIDE[12]-[12]$ TRACE
#DIGIPEAT 0 1 ^WIDE[3-7]-[1-7]$|^TEST$ ^WIDE[12]-[12]$ TRACE
#DIGIPEAT 1 0 ^WIDE[3-7]-[1-7]$|^TEST$ ^WIDE[12]-[12]$ TRACE
IGSERVER northwest.aprs2.net
#IGLOGIN YOUR INTERNET LOGIN AND PASSCODE FOR APRS REPORTING
IGLOGIN xxxxx #####
TBEACON sendto=IG delay=1 every=60:00 symbol="igate" overlay=R
IGTXLIMIT 6 10
GPSD localhost
