You have a radio I do not know anything
about. I’m only about a week ahead of you in learning how to
make DRAWS sing. I just happened to have been working with
fldigi and my IC-7000 and the questions you asked were central
to making fldigi work with the DRAWS hat audio device and that
How did you configure fldigi to key your
radio? Since you are no longer using a SignaLink, you can’t
rely on the SL VOX keying circuit. If you want to use VOX for
PTT, the radio has to have a VOX function and it has to be set
up and adjusted.
Only other approach I can think of is to
make sure your radio can be controlled and/or keyed by flrig’s
CAT control and set it up. Then set fldigi to control and key
the radio using flrig. That seemed to work for me with my
IC-7000 and Yaesu FT-817.
Sorry I can’t be more helpful.
Next issue is with getting the radio to transmit. First off,
I have used Fldigi with the TM-V71 many times on vhf uhf with
success using a signalink and a sound cards with simple
interfaces. I noticed right of the bat that the squelch on my
radio does not stop the waterfall with the DRAWS
interface...what is that about? Using the alsa mixer control
no value of ADC changes the waterfall appearance, it doesn't
dim or get brighter with open squelch. Squelching off the
signal of the radio does not stop the water fall ??? I have
never seen that before. Lastly I cant key the radio and no
value of Lo Drive Gain or PCM makes any difference.
Do you have any suggestions ???
On 12/23/2018 5:58 PM, Jack Spitznagel
- Check to
make absolutely sure that Direwolf is not running after
- If it is
not running, you should see PortAudio as a selectable
option. Check the box.
- Now Select
udrc: - (hw:0,0) for both capture and playback.
- You can
also check “Device supports fell duplex” (it is in mine by
default and I just left it that way)
Hope that helped.
On Behalf Of Joseph Vilardo
Sent: Sunday, December 23, 2018 16:49
Subject: Re: [udrc] amixer questions Re: Set Up
Issues #setup #fldigi #draws
I am looking for some basic guidance on
getting fldigi configured for VHF and UHF. I have been
successful with the DRAWS Beta 5 image and running
Direwolf/YAAC and now that I know the "core image" checks
out and works. I rebooted the PI/DRAWS combo and shut down
Direwolf and ax25 with this command sequence: cd bin, sudo
I then selected fldigi from the drop down menu on the home
screen of beta 5 image. When the configuration helper for
fldigi comes to selecting the sound card I am left with one
option and that is to select "pulseaudio" and it responds
wit no pulseaudio server. It doesn't give me an option to
choose udrc 0 or 1.
What do I do from here to get an audio source selected ???
Science River LLC