toggle quoted messageShow quoted text
I followed the steps below but didn’t see the two mentioned lines. So I will do the whole installation process, written down in the „Raspberry-Pi-ARRS-Tracker.pdf”.
Will get back with the result...
Am 05.03.2019 um 22:19 schrieb Basil Gunn <basil@...
If you are talking about Xastir, it is installed from a debian package.If you are talking about Direwolf, I treat it like a modem and do theapplication stuff from applications.From the direwolf doc it seems like if gpsd & libgps-dev are installedbefore direwolf is built then it will build with gps functionality. Thatis currently NOT the case. To fix this, since gpsd & libgps-dev are installed, rebuild direwolf. cd /usr/local/src/direwolf-dev make -j4 sudo make installLook for the following printed out at the end of the make
Basil, does the beta build have GPS compile switch turned on, it is not
default in the make
This includes support for gpsd./Basil
This includes support for hamlib.
On Tue, Mar 5, 2019, 12:09 Rico Abagnale <rico@...> wrote:
thanks for the update.
All commands figuring out whether gps works report a normal behavior of
the gps module.
However, when I tell direwolf to beacon regularly the position taken from
the gpsd, nothing happens. Calling „systemctl status direwolf” shows a
fault message that gps has to be configured first. So it looks as if
direwolf doesn’t want to use the data of the gpsd.
*Tel.: +49 (0) 70 42 8 12 42 45*
*Fax: +49 (0) 70 42 8 12 42 46*
*mobil: +49 (0) 171 45 10 711*
Am 05.03.2019 um 21:04 schrieb Basil Gunn <basil@...>:
Thank you for sending the output to showudrc.sh
Everything looks to be OK for the DRAWS hat.
I just configured a new instance of Xastir and find the same symptom as
you do. I have a call into one of the Xastir dev's to see if we can find
a solution to this problem.
I also configured a new instance of YAAC and gps works fine through the
gpsd tcp interface with this app.
To verify gps activity from the DRAWS hat you can run either of these
commands in a console.
Rico Abagnale <rico@...> writes:
here comes the output of showudrc.sh. It’s quite long…
After the listing you can find a screenshot of the settings for the GPS. I
hope that’s what you meant.
Many thanks for your help…