Re: Not booting


Thank you.  I tried on a pi without the hat and it did not boot.

Does draws 11 have the same isdue with updating?

Granada Estates Neighborhood Watch

On Sun, Jul 14, 2019, 17:33 John D Hays - K7VE <john@...> wrote:
I don't have any specific information on RaspAp.  However, people have been advised not to do a general update on Beta-11 with the DRAWS™, though I doubt it would prevent booting.  Will the Pi boot on the image without the DRAWS™ attached?  If not, then it is likely not a DRAWS™ problem.

People have been successful using DRAWS™ with the new Buster Raspbian (see thread on here).  If you make a new image, be sure to backup your current image so you can roll back.

On Sun, Jul 14, 2019 at 3:39 PM Douglas KI7LIK <KI7LIK.AZ@...> wrote:
It seems as if the problem is when i try to update the distribution.   After i do such and do a sudo reboot, it only shuts down and not boot up.

On Sun, Jul 14, 2019, 14:12 Douglas KI7LIK via Groups.Io <> wrote:
I write a new card with draws 11 that i had on my computer.   It booted up normally and went through and checked out with the normal set up in getting started.

I tried to install rasp ap before updating via update and dist-uprade.

I then did the update after not being able to install raspap.  I then did it in proper order and rebooted before setting raspap.  It shut down, but not restart.   I then booted up the pi with a different card and its fine.

What mistakes could i have made and is there a way to correct them?

Thanks for your help,

Granada Estates Neighborhood Watch

John D. Hays
Kingston, WA


Join to automatically receive all group messages.