toggle quoted messageShow quoted text
Ah!!!?? Good to know.?? I will shut it down.
On 9/14/2019 7:19 PM, John D Hays -
Manager does not need to run all of the time.?? It is
a setup tool, then you can shut it down.??
sudo systemctl stop draws-manager
and to prevent it starting??up on next??reboot
systemctl disable draws-manager
Or you can move it to a different port, as documented here
# If you want
to set the port, edit /etc/default/draws-manager and add a
line with the port number, e.g. PORT=80 (it defaults to
systemctl restart draws-manager
There are two issues to take care of here.?? As was
mentioned, 0.0.0.0 is not the address for you to use.??
When you are accessing a web page on the same machine
you are using, the "loopback" or "localhost" address is
The other thing to take care of is that it's
necessary to change the default port used by PAT since,
as you mentioned, 8080 is used by the DRAWS Manager.
So, as you might have already done to setup your call
sign in PAT,?? type "pat configure" from a command
prompt.?? Scroll down a few lines and change the port to
something other than "8080".?? Here is what that line
looks like in my setup, for example:
... so, if you use 8888, the URL to type into your
browser (after typing "pat http" in a terminal window)
And you'll be all set!
Do you have any suggestions on the IP Address for
PAT with the DRAWS.
When I enter 0.0.0.0 I get an error when starting
PAT (address already in use).
When I enter 0.0.0.0:8080
in the browser, I am given the DRAWS Manager web
interface page when 0.0.0.0 is used in the config.
The same results are received when I use
localhost in the config (address already in use
and same web page).
I am connected directly to the Pi as I would be
in the field (upcoming exercise).