toggle quoted messageShow quoted text
There’s an 8 pin 4x2 header next to the power connector. Check below the schematic for pin-outs.
On Nov 23, 2019, at 5:23 PM, Ed Bloom, KD9FRQ via Groups.Io <ewbloom@...> wrote:
I have a -62 Cat to USB Serial on hand. So, for the FT-897/857
we need two cables, one for CAT and one for Audio via the DRAWS.
So, to which port does DRAWS cable connect?
On 11/23/2019 6:07 PM, Ruben . wrote:
I’m working on a similar issue with FT-857. Finally realized that
I needed an additional cable for CAT. Ordered an 8-pin mini-din
cable and located a source for the header connector.
I’ll post with results once CAT cable is configured.
On Nov 23, 2019, at 3:52 PM, Ed Bloom,
KD9FRQ via Groups.Io <ewbloom@...>
Has anyone connected their DRAWS to an FT-897
yet? I am looking for some assistance.
Specifically, cabling needs for the setup.
It looks like from all I have read, I still need a USB to
Serial to run any Rig Control outside of
Is this correct?