I appreciate your precisions concerning DRAWS use with nwdr14 distro.
However there is a complete discrepancy between what you suggest and what is explained in the
"Getting Started Guide"
In the above guide is written to execute script _appconfig.sh core in Initial Configuration.
On the contrary you wrote
https://github.com/nwdigitalradio/n7nix/blob/master/docs/IMAGE_README.md)However, direwolf is not installed in nwdr14 image.
Currently you can switch between vhf/uhf packet & HF programs byImmediately after first initial distro configuration ax25-status shows that AX.25 pplications are not RUNNING and NOT ENABLED.
Executing ./ax25-start fails with error code due to direwolf port not found. There are a few reasons for this. First /etc/direwolf.conf is not configured for DRAWS device is commented together with PTT GPIO is not set to 12 (default left DRAWS plug).
#PTT GPIO 25
If /etc/direwolf.conf is configured for DRAWS before running ./ax25-start things go much better.
In order to check if AX.25 is now correctly set up I started YAAC application and listening to APRS frequency.
No stations could be decoded.
I had to execute setalsa-udrc-din6.sh script.
At this step, to be able to get a functioning APRS application I found it is abolutely necessary to switch Raspberry Pi power OFF and ON to reboot. Otherwise, direwolf is not getting DRAWS audio.
After these mandatory successive procedures, measure-deviate script was found to be working correctly and beacon application could also be activated.
I will continue further in order to find the correct order of scripts execution steps toward ax0 and ax1 configurations for other AX.25 applications.
73 de Bernard, f6bvp