toggle quoted messageShow quoted text
A month ago? Yes
You can verify just by looking at the board with a magnifying glass and comparing to the photo.
The yellow resistors will be marked 104 instead of 100.
We’re figuring out how the best way to handle the rework and will post once I return to the office.
On Dec 22, 2019, at 7:34 PM, Ruben . <email@example.com> wrote:
If we are affected by the error, will we be notified? I’ve had mine about a month.
I’ve configured the software, but have not yet transmitted, everything works on receive. Getting antenna and go-box built to enable portable operation. The Pi-DRAWS case would be real helpful.
Also installing Auto-Access Point and WinLink PAT configuration by KM4ACK.
I can break them, but I can’t fix them.
Thanks and 73,
On Dec 22, 2019, at 12:53 PM, Bryan Hoyer <firstname.lastname@example.org> wrote:
David, you are right!
100ohm Resistors we’re incorrectly Stuffed as 100k creating a 20dB attenuator.
I should have caught it when we had the cap problem.
With the new run, 8 Components were stuffed incorrectly:
C17, C20 (0603) should be 0.1uF but 10uF was stuffed
Easiest Fix is to Remove
R20, R21, R26, R27, R39, R40 (0603) 100ohms but 100kohms was stuffed
Easiest Fix is to solder 100ohms on top (in parallel)
Assembly has current stock in for re-work.
We’ll make it right for boards in the field, whatever it takes.
I’m out of the office until January 6th.
Thanks for your patience,