Charles Blackburn <wx4cb@...>
not using a draws yet, but i am using ham radio deluxe on my laptop and i have the settings as below, just remember for it to accept out of the data port, you need to tell it specifically to use the correct TX cat command (there's two). as per page 21 of the command manual: https://www.kenwood.com/i/products/info/amateur/ts_480/pdf/ts_480_pc.pdftoggle quoted messageShow quoted text
IIRC it's TX1
TX - Sets the transceiver in TX mode.
Parameters: P1 0: Normal (SEND) transmission using MIC input
1: DTS transmission using ANI input
2: TX Tune transmission
If no P1 parameter is specified, P1=0 is used.
TX Audio Source Rear/Data
hope this helps
On 2/5/2020 12:00 AM, Jonathan Visser via Groups.Io wrote:
I am working to test WSJT-s on the latest image of DRAWS image.