Re: XASTIR unable to start interface



I tried the first, setuid solution. Also worked like a charm.

As always, many thanks for your support.

John KM7LJ

On Fri, Feb 7, 2020 at 4:04 PM Basil Gunn <basil@...> wrote:

Hi John,

Two solutions
First it is mentioned in the Xastir INSTALL file and in their FAQ
that to use AX.25 the xastir run time file must be setuid.

sudo su
cd /usr/local/bin
chmod u+s xastir

After the xastir binary permissions should look like this:
ls -al
-rwsr-xr-x 1 root root 1178192 JanĀ  6 13:34 xastir

Also you could try using Xaster interface AGWPE localhost:8000.

I will add this to the Xastir install script.
/Basil n7nix

jgindc1@... writes:

> Basil,
> Now with XASTIR running I am attempting to set up the interface with DRAWS via Interface Control:
> Interface type AX25 TNC, and AX.25 Device Name udr0.
> Interface START has no effect, the interface remains DOWN. I have tried moving the radio (FT-817) mini-DIN connector to the DRAWS right mini-DIN and set the AX.25 Device Name to udr1. This interface also does not START.
> I have checked that.
> 1. Direwolf and AX25 are running (ax25-status)
> 2. APRS packets are being received successfully (tail -f /var/log/direwolf/direwolf.log)
> 3. APRS position beacon sent ok (verified with aprsfi).
> Again, I have had XASTIR operating successfully using the same XASTIR interface setup with earlier versions of the Compass image.
> I wonder if there is some other parameter(s) that I have forgotten about.
> Thankls,
> John KM7LJ

Join to automatically receive all group messages.