Re: DRAWS - not able to receive APRS #aprs #direwolf #ax25

Mark J Culross

Corky (AF4PM):

Thanks for your reply.  I did try combinations of turning 9600 on/off on the radio, along with setting pin 4(DESC) / pin 5(AF) in DRAWS manager, all with no detectable difference in decoding.

I found reports in the forum of better decoding using the discriminator pin.  However, by default, the "" script deactivates the "IN1" inputs (9600/discriminator) & activates the "IN2" inputs (1200/AF).  I temporarily modified the script to reverse this, again with no detectable difference in behavior.

The <> reference gives a nice interconnection diagram with a great explanation of the hardware plumbing.

Thanks again for your reply !!

Mark J Culross

On Sunday, September 13, 2020, 12:05:33 PM CDT, Corky Searls <af4pm@...> wrote:

Mark, a quick question regarding the IC-7000 config. Do you have this set for 1200 baud or 9K6? You will need to make sure that you are listening to the correct pin on the mini-din connector.

I believe the default for AX25 is the 9k6 pin, so you may need to set the radio to 9k6 (this just provides audio directly from the discriminator and does not really affect the actual baud rate)

Thanks and 73,
-Corky, AF4PM

On Sun, Sep 13, 2020, at 7:06 AM, Mark J Culross wrote:
I finally found some time to play with my new DRAWS (attached to RPi3B+, running current image dated 2020-Aug-22), but I've run into a roadbock.

To start, I followed <>

I then followed <>

The radio (IC-7000) is attached to the left side DIN6 connector (udr0).  I also ran the setup script.

I've attached output files with the results from the following commands:
- ax25-status
- ax25-status -d

I have run each of the following at the root command line, but other than showing when I send a test position message using, none of them show any indication of any APRS decoding (although I am tuned to 144.390 & can hear lots of packet activity from the radio):
- tail -f /var/log/direwolf/direwolf.log
- listen -a -h -i -p udr0 -r -t
- mheard

Any suggestion on what to check next ??

Thanks in advance,

Mark J Culross

  • ax25-status.out
  • ax25-status-d.out
  • ax25-showcfg.out
  • alsa-show.out

Join to automatically receive all group messages.