Re: Pat ARDOP configure issues #pat #rigctld


 

What are you using as your CAT control cable?   Usually something like


On Sun, Jul 11, 2021, 11:30 Richard Gilbert via groups.io <rpgilbert1=verizon.net@groups.io> wrote:
Trying to set up Pat following the KM4ACK videos and descriptions listed here. ARDOP loads, rigctld gives the error below Pat http loads but says it can't get the frequency from rigctld. I'm using a FT-818ND. Hardware id is 1041. There is no ttyUSB0 in the /dev/ folder so I must have missed something somewhere.

pi@draws:~ $ rigctld -m 1041 -r /dev/ttyUSB0 -s 4800
rig_open: error = IO error
port_open: serial_open status=-6
iofunc.c(80):port_open return(-6)
rig.c(773):rig_open return(-6) 
pi@draws:~ $ 

Suggestions, please
Richard KI5EVJ

Join udrc@nw-digital-radio.groups.io to automatically receive all group messages.