They are in rework now for LEDs BW. Should be shipping next week. Bryan K7UDR

John - Is there a target date you hope to begin shipping the units? 73 Mike KB0FX

k7udr posted: "First units arrived Saturday, and we have been testing thru the weekend. DRAWS is fully functional and we have a few minor assembly issues to resolve before shipping.

I have an opportunity to pick up an extra radio for digital use. I am currently running a Yaesu FT-7800 and it works very well with the DIN plug on the back of the rig. A friend wants to sell his

I will give that a check soon. Thanks!

I can verify that the non-refurbed DR1-Xs both 1.0x and 1.10x firmware work with proper d-star audio levels with UDRC-II with firmware in the past 18 months. I have been told that the 9600 baud

We don't know for sure, but we think that the refurbs are actively trying to block any external modem. The original should have worked, if the directions were carefully followed (with no internal

It is a refurb, but I don't recall the firmware version off the top of my head. We also tried it with the non-refurb DR1X that we have, and had the same TX audio issue. The levels would just never

Is the DR-1X a newer referb? What firmware does it have? -- John D. Hays Edmonds, WA K7VE

I am attempting to make a straight through custom cable that breaks out the PTT and Audio Out lines. I have performed the modification to the DR1-X cable that connects the receiver and transmitter so

The UDRC/UDRC-II 15-PIN connector is aligned to connect to the DR-1X HD-15 connector using a straight through 15 line cable. This was created to be a plug to plug connection. We are not sure that

I have a question about the pinout shown in the wiring diagram. Is this shown from the rear, or from the front, like you were looking at the connector face? The pin orientation is off from that of the

It appears that is not the case. RMS Gateway upgrade notes for new Winlink Web Services https://groups.yahoo.com/neo/groups/LinuxRMS/conversations/messages/2775 /Basil n7nix

Jeez, give it a rest.

-- Update? Paul kc7pmu

Thank you Annaliese. I have been writing OS’s and device drivers for more years than I like to think about. You have given me what I think I need and I won’t bug you. I will make anything I get

The UDRC driver expects to see a bcm2835 i2s device to set up the DAI links. You’ll need to write a new ASoC driver if the I2S device isn’t compatible with the bcm2835 one, which is pretty

Yes, all of the necessary signal lines are present and it works great with either a KX2 or KX3 (both use the same cable). I can post a copy of the connections for the cable early next

The mini-6 din has what is needed to make a “cable” to the mic and headphone jacks on the KX3. You can also make a plug for the 4 x 2 connector on the DRAWS with a RS-232 level shifter chip to

The pinout for the mini DIN-6 is the same as has been used for 'packet' ports on Yaesu, Kenwood, Icom, .... for years.-- John D. Hays Edmonds, WA K7VE