>> ... And encourage the NWDR folks to add the 3 or so resistors needed to DRAWS on the next rev so it will also have the CTT/CI-V cable functionality. Bill, wa7nwp

While the beta image is being prepared, I recommend the directions at http://www.kk5jy.net/fldigi-build/ for building fldigi and flrig. I have done this build and it works fine on the left DIN-6

I find the waterfall on fldigi and wsjt-x work better than my ears for finding signals. The idea of the pigtail is to be able to put whatever you want on the other end. The 9-15 VDC input to the

Please leave the 10 KOhm settings in place. ADC (Analog Digital) is the control for setting the level from the receiver. In packet with Direwolf, you can tweak it until received signals are

The muting is great for packet but once we get fldigi working I’m going to need that RX audio to find signals. If we can’t do it in software then I’ll have to savage one of these cables to

Hi Brian, My testbed FT-817 does the same muting (but I like it). I am listening to transmitted audio with a TH D74A. DRAWS receive audio was basically fine after I ran the bash script for setting

I have Direwolf running now, but I couldn't deduce which of these three parameters was "input sensitivity" -- instead I changed the impedance from 10 kOhm to 20kOhm to get the levels right. What is

When you create the script (put in ~/draws-setup.sh or similar) then you can execute it anytime you want to set values for the sound chip. If you find you need to modify the 3 above values in

All DRAWS owners, Setting up xastir for the DRAWS board was not a slam dunk! This message is longish but my discoveries and explanations here may help if you are relatively Raspbian naieve. If you

gpsd is up. Thank you for adding this to the wiki so quickly. — Brian N0KZ

I updated the Wiki page to note this requirement. -- John D. Hays Edmonds, WA K7VE

There is no separate GPS driver. If you are not seeing /dev/ttySC0 then check the last line of /boot/config.txt and make sure it indicates draws instead of udrc. If you need to change it, you will

These device files do not exist. I am using the latest version of Compass, fully updated. What is the gps kernel module I should be looking for? — Brian N0KZ

Thanks all, I will go back through and rerun the initial setup scripts to be sure everything is set back to defaults and see if that makes a difference. Thanks, Matt

It can be anywhere, but following those instructions that is where it ends up. -- John D. Hays Edmonds, WA K7VE

John. The script you are referring to is the set-udrc-dr1x.sh file in the home/pi directory correct? de Mike

Also, always start with the values in this script https://nw-digital-radio.groups.io/g/udrc/wiki/UDRC%E2%84%A2-Setup-for-the-Yaesu-DR-1X-Repeater#Basic-Configuration -- there are additional settings

Thanks for the suggestion, but I have tried varying PCM, ADC and Lo levels up to the max and the output signal isn't changing. I think the signal I am seeing on my SDR is just carrier or noise. I also

Hi Matt, On rare occasions (which to this date, I still don't know the cause) my DR-1x TX(PCM) audio level on the UDRC gets reset to zero. Check yours. In my case, I set both audio levels to 48, If

I am configuring a UDRC II with DR-1X repeater. Looking at the dstarrepeaterd_1.log file I see my HT's transmission being received/decoded, but I do not see it being repeated or TX. For normal RF