In general for debugging problems: Send output of: ~/bin/showudrc.sh ~/n7nix/debug/alsa-show.sh Use the following instructions for measure_deviate.sh to verify PTT & transmit

These CR1220s work well in mine: https://flic.kr/p/2dEEz8v 73!! David (KG5EIU)

Yes. Exactly what I was going to do. Just want to make sure that is sufficient to solve Gayland's problem. /Basil

Basil, John, All, Initially, Beta 5 seemed to work out of the box but I ran into some DRAWS audio and keying strangeness that is baffling me after 3 tries at installing from newly flashed microSD

Battery is CR1220 NON RECHARGEABLE

If not already present adding in n7nix install core script could be usefull to perform initial system time adjustment when GPS is not yet switched. This is my case for I did’not put any antenna

I did not install a battery yet in my DRAWS hat. None of the button batteries I have in stock fits into the case. Could someone give me a model reference or number. Bernard

From some google-fu: Note that the chrony service does not change the time. The often misconception is that the chrony service is setting the time to the one given by the NTP server. This is

Not to sound too dogmatic but text editors are personal and I've had this discussion a few too many times already. Put whatever editor you want on your installation but it most likely will not be in

I just loaded beta5 and going through it, I'll make a list here of suggested apps for the final image (or at least that people should consider installing) - geany: great little text editor, multiple

I believe it ran for a few hours without the update, in fact I was surprised when I finally noticed that the date and time were so off. I did not do anything with chrony nor the gps other than

My experience is that it can sometimes take 10 minutes for chronyd to sync. /Basil

The RTC is part of the GPS and is set by the GPS, make sure your GPS is receiving to get the RTC set, you can use gpsmon or cgps to check the gps. Then gpsd and chrony need to be running for the

FYI, I installed a battery before I first powered up the DRAWS but the time did not update even with a network connection and the gps antenna installed. I ended up setting it manually using the date

I will add that if you go into /etc/chrony/chrony.conf and modify the line for PPS and add prefer to the end, that should give you the most accurate time when the GPS is running. refclock SHM 2 refid

Bernard, I have been playing around with chrony for a few hours now and I've convinced myself that chronyd should work fine with or without a gps antenna connected. If you look at the output of this

Yes good idea. /Basil Bernard Pidoux <bernard.f6bvp@...> writes:

Hi, I would prefere to have IP address of AX25 ports being set as parameters rather that fixed IP values inside the script ax25-upd. Something like : PORT_1_ADDRESS=« 44.168.xx.xx

Not yet. That is our vision for config as well. Nice!

Ok. I reinstalled chrony for it had been removed when installing ntp. This time command systemctl status chrony showed that it was started as ntp client/server and chrony sources command found 6