$129.99 + shipping to lower 48 US

I have an older FT-450......and my DRAWS will arrive as part of the next batch...... Are you saying that I still need some additional equipment to go between the RPi and the radio along with the

Hi Jack, the ft-450D is the new version and it has the same issues of being over driven. Tigertronics used to have you put a resistor inside the signal link box to cure it on the audio out line. But

Hello everyone and Merry Christmas, This has most likely been covered before but I can't find it. How do I get the system time to automatically set from the draws gps at bootup without internet

Basil, Found what I thought I remembered about IC-7000 data port sensitivity in the SignaLink FAQ at www.tigertronics.com. Obviously this will have an impact on DRAWS setup and operation with the

Finally after many frustrating days, wsjtx and js8call are working with the draws hat. It was my fault and probably a rookie mistake but I will explain in case others are making the same mistake. It

Stand corrected.Still a lot to learn (and relearn) since I last looked at this about 25 years ago. Jack -- J Spitznagel Science River LLC KD4IZ

Jack: AX.25 isn’t needed for Net-44... that’s a TCP/IP function. -- Steve Stroh (personal / general): stevestroh@...

Art - KC7SDA <nouse4anick@...> writes: As another FYI you do NEED AX.25 for Winlink on the RPi, paclink-unix & Linux RMS Gateway, also the BBS. Also it is much easier with more capability to

Art, My experience as well, except when one might want to setup tunnel connection as part of the ampr.net (“44.” Net). I plan to be doing that with some DRAWS functions. I thought that was a

That is correct. Direwolf can run independently of the AX.25 stack. And programs that can talk directly using agwpe or kiss over the network work just fine (e.g. YAAC, Xastir). Basil has done a

Basil, John I setup Beta 6 today. The install was painless, it may be my growing comfort with the setup, but it ran smoothly. Testing was where thing fell apart. Unfortunately I still struggling to

as an fyi you don't NEED ax25 to run direwolf, I never installed the AX.25 stack on any of my ham computers and I can still run direwolf and xastir perfectly fine

Read this: https://github.com/nwdigitalradio/n7nix/blob/master/DRAWS_CONFIG.md The step where you run app_config.sh core setups up your image & starts direwolf from systemd. If you read to the

I hate to admit this but I don't know what is meant by "run Basil's scripts" Was I supposed to do something after the first boot up of beta6 ? Everything looks normal after the boot up. Exceot ft8

Thanks for the killall direwolf suggestion but I seem to have deeper issues. The response to that command was "direwolf: no process found" I have downloaded the Draws beta6 image about 3 or 4 times on

Hi Basil, Thanks! That will help. Jack

Hi Jack, In the beta6 image after you have run the app_config.sh core script most of the commonly used scripts are copied to the local bin, ~/bin and that will be in your PATH if you are logged in as

John and Basil, Good point on the appropriate scripts (not just killing direwolf)! I will be loading Beta 6 later today… Suggestion: Is there any way these script functions can be put

This will leave the AX.25 stack in a weird state, please use Basil's scripts to start and stop AX.25 and it will start/stop direwolf. If you start direwolf without AX.25, then it can be stopped