k7udr posted: "The DRAWS HATs are in stock but the announcement of the Pi 4 has changed the landscape.We have Pi 4s on order, and a few of our customers have DRAWS working on the Pi 4 now (see our

Matt, You may want to reset the radio. I have done that in the past when problems arise. I use the included menu settings after I reset the radio. I am using the left audio channel. Have you checked

I had a PIJuice hat between the Draws Hat and the rPi 3b. showudrc.sh text showed that I was missing the UDRC radio. I placed the Draws Hat onto another rPi without the PIJuice hat, and the UDRC

Thanks all for your suggestions. I've made sure that my "DATA IN SELECT" (setting 08-09) is set to "REAR" rather than "MIC", and confirmed this by whistling into my mic while transmitting. No

You never know until it is tested, but with Anna's driver for sound and serial in the kernel it should just move forward. -- John D. Hays Kingston, WA K7VE

FYI: While you are waiting for your RPi4 to arrive, you still prepare a SDcard with Raspbian Buster (the new version needed for RPi4) on an older RPi. I followed LA4RHA, Lars' guide (and hopefully

David Nussdorfer <davesworld06@...> writes: No new information from you to comment on. I'm guessing the tlv320aic driver is not loading for some reason. The output of showudrc.sh would confirm

Thanks for replying Basil. The instructions do not call for a play -l until configuring the sound card. The instructions link you posted is the one I used twice to configure the Draws Hat on a rPi

Hi Lars You can fix the loading of js8call and wsjtx by using sudo apt-get install ./$findname instead to sudo dpkg -I $filename. Apt will resolve the missing dependencies. It just needs to know it

If you read the Getting Started Guide https://nw-digital-radio.groups.io/g/udrc/wiki/DRAWS%3A-Getting-Started you will see all you need to do after the initial config is to

Not sure how to set up the IPTables for AX.25, so I used my wireless access to my router during the config setup I used the IP address twice during the setup. Unfortunately, the information to set

Thanks John.

I don't have an 857 but the settings for 8x7 radios seem to be about the same. In DRAWS™ Manager, try the default settings for the FT-817 and make small changes from there. -- John D.

Running JS8Call and monitoring on a station in the adjacent town via VNC. Remote station is ~15 miles away. Operating on 40M. Beta13 Yaesu 857D Before I moved to the DRAWS unit, I ran a test with my

Be aware that the 2.1.0 rc7 version does not now transmit data on my Mac. Apparently has some built-in switch to turn it off during some periods. Version 2.0.1 does work on the Mac and the 3B+ under

Have you looked at the output settings in draws manager and tried to adjust those? Have you confirmed that the audio settings are correct for transmit in the wsjt-x program? Lastly, have you adjusted

Hi Matt. Make sure the radio is getting the input from the 6-pin data port. I don't have a FT-891, but look into mode. Could be called USB-D, DIG or similar. I've had similar problems were other

Hello, I've been trying to set up my DRAWS and FT-891 to use FT8 via WSJT-X. I've been following the videos and settings from Julian and Steve, and can receive messages ok, however whenever I transmit

I have amended the document with the comments from John regarding the file. Have also added some comments about installing DRAWS Manager ("Follow the instructions at...") /Lars - LA4RHA

Thank you for the heads up, Basil ! /Lars - LA4RHA