Hi Jonathan, all. I'm puzzled by your "dtoverlay=" observation as that certainly was not required on either my Pi3 or Pi4 running the same Buster image. I wonder if some of the confusion has to do

Rob, you are contributing to the advances of mankind. Think of your purchase as an investment in progress. I follow this conversation daily. I ordered mine in early Spring- as soon as presales were

Hi I just wanted to let the group know that I have made good progress. I started from scratch with a clean buster image and using my Pi3B (to rule out any issues specific to my PI4). With just the out

just did a rest on the radio and still no transmit powers and also don't see how it can be the radio if it works with other soundcards. just tried the setalsa-ft817.sh command again no joy I have also

The FT-817 is probably the most tested for the DRAWS™ HAT. Are you using the left DIN-6 port and selecting the same in your program? There is a possibility that one of the flags in the CODEC was set

And make sure the lines are added at the end of /boot/config.txt in that order. dtoverlay=draws,alsaname=udrc force_turbo=1 -- John D. Hays Kingston, WA K7VE

Hi Basil, Sorry to have wasted your time. 73 - Frank - K0FEI

yes over and over went home to day and rechecked the radio settings. I would think if the radio work in receive and with a signal link the radio settings should be right. last night had the drive

Thanks for the documentation of the DRAWS Hat! Several questions are answered here. Thanks, Mike WF8O

Provide the output of showudrc.sh describing what you did doesn't work for me. lsmod | grep -i tlv320* snd_soc_tlv320aic32x4_i2c 16384 27 snd_soc_tlv320aic32x4 40960 1

I'm sorry Jonathan, You did show the showudrc and it shows some of the modules, and the /boot/config.txt. If could show all the modules the sudo lsmod and the /etc/modules file that would be

Hi Basil, Just adding the lines to /boot/config.txt didn't get the tlv modules to load and I could not see the sound card. If I put those lines before the drtparam=audio=-on then aplay -l said there

Hi Jonathan, Could you look at a couple of things and tell me what you are seeing. 1. Could you enter sudo lsmod. That should display a list of kernel modules loaded. 2. Could you cat

Have you read this to set up a "USER" defined digital mode on your radio? https://github.com/nwdigitalradio/n7nix/blob/master/docs/RADIO_APP_NOTES.md /Basil n7nix

It’s a ft-817nd

Frank, I am using the card with the GPS antenna on what I would consider the back. The GPS antenna antenna is on the same side as the power. Thanks, Jonathan

https://nw-digital-radio.groups.io/g/udrc/files/DRAWSTech.pdf -- John D. Hays Kingston, WA K7VE

I read several posts here about the need to remove pin six. John Hays and Bryan Hoyer particularly seemed to have solid reasons, and I merely took their helpful advice. The Draws Hat is essentially

Stretch is the best path for Pi 3 and Pi 2. If you have a Pi 4, you will need to use Buster and the edit that Basil lists. Now that the DRAWS™ support is directly in the Buster kernel, it is

I have had both recognized with the Buster version. -- John D. Hays Kingston, WA K7VE