Because I don't support PAT. I support paclink-unix. Without showing me (cutting & pasting into post or email) the console output of the error message I can't really comment. Verify that ax.25 is

Hi Dave! I believe this is the video that I used to get setup for PAT over ax25: https://www.youtube.com/watch?v=o8OBF47UkeI&t=509s -Scott, K4KDR ========================

I can not find the PAT CONFIGURE setup for ax25 VHF ports. I had ax25 started and when I attempted a packet connection the error message said that a ax25 port was not found. What do I need to change

Where in the command that you gave is the syntax for the USB device you are using? dsnoop:1 ? If I use cvlc --longhelp it lists alsa audio devices so I'm guessing you would replace dsnoop:1 with

Heh, I guess it's all relative. :-) I'm used to a minimal image that basically just gets the machine booted with all the hardware usable. I suppose in UDRC/DRAWS terms, that'd be the necessary

I am using my Draws Hat mainly for WSJT-X. I have a quick question: I would like to stream audio to my local network. On my other setups (Raspberry Pi3) using a signal link USB audio card, I

Did not know that. Usually the first time you edit one of the system files like a crontab entry you get presented with a menu of all the editor choices. I don't mess with any default system settings

Thanks for the reply Basil. I am a real Newbie to DRAWS and Linux but I muddled through the install until I went to setup ARDOP from the web and then later discovered there was a script to do that.

I see that I'm now subject to moderation on my posts. Why is this? Is it because I'm again asking where my early adopter aluminum case is? August KG7BZ

Thank you. draws manager is setup and I put the settings in for the 500 mv setting for the kenwood tm 707. I am still having the issue with input device and rig control errors.

https://youtu.be/v5C3cWVVz_A

Under the input device settings, which one should i use? I can't seem to get the correct one. Also, how would I adjust the alsa settings manual for the draws?

I now have a script, chk_gateway.sh, that I would like to see the console output of. # To get the script cd cd n7nix git pull # To run the script cd rmsgw sudo su ./chk_gateway.sh Copy the console

Please read my previous email & do everything that I asked. /Basil Craig McVeay <cmcveay@...> writes:

I ran the scripts that you sent and here's what I have. Here's the output of the ls -sal /usr/local/etc/rmsgw total 196 4 drwxr-xr-x 4 rmsgw rmsgw 4096 Nov 6 04:11 . 4 drwxr-xr-x 4 root root

You may have a file permissions problem in the /usr/local/etc/rmsgw directory. Verify by sending me the console output of: ls -sal /usr/local/etc/rmsgw You can solve the problem by running a new

Basil, Yes on the gateway request, I've had a gateway running (RMS Packet on a Windows machine) for a little over a year. If I have that running on the windows box while I'm setting this up on the

Your ax.25 status looks good and is running properly. You have something incorrect in your RMS Gateway config. Have you made an authorization request for an RMS Gateway

I get much less errors, now I get the following: 1: Error in Sound Input Requested Input audio format is not supported on device. 2: Rig Control Error Hamlib error: IO error while

Progress is being made. I started with a fresh copy of the latest image. I went through the getting started, learned a few things along the way and this is what I am getting now. I think this is