If you are setting up Claws-mail, make sure that you follow the Claws-mail setup instructions exactly as described here: https://github.com/nwdigitalradio/n7nix/blob/master/email/claws/README.md If

Since I finally got a second antenna up and the second 2m rig, I now have my DRAWS running APRS on udr0 and wl2kax25 sending and receiving on udr1. Claws Mail is properly sending mail out and

Great to hear Mike.

Yup did the same procedure and it worked on my old install. Mike

On your old install should be able to refresh your files cd cd n7nix git pull cd config ./bin_refresh.sh and run the iptable-check.sh script iptable-check.sh

This is on the new image that I listed above...I didn't burn a new one...(in my case ax25 was already running by now) I did not need delete the lines. This a completely different output than what I

Thanks for the console output. The raspbian distro version of iptables has recently changed and no longer allows setting iptables rules without the ax.25 interface(s) being up. That means the place

Ok gave up on other fixes..downloaded the fresh Draws version 16, wrote it to a new unused sd card... ...started from new on the 'Getting Started'

Basil, You are busy enough handling my dumb questions! :) Sent through two tin cans on a string.

J P, Thanks for providing detailed instructions on teamviewer. Not that teamviewer isn't an effective tool but really all I need is to ssh into an RPi. <The rest of this message is a rant> Having

Basil, Rather than HIJACK another thread, I recommend the installing Teamviwer on Buster to be able to remotely assist others with issues. Install Teamviewer # install teamviewer for virtual remote

I know passing emails back & forth is not very satisfying when trying to fix problems. If I was in front of your RPi I could fix your problem in short order so it is a little frustrating for both of

I would like to point out that I was running an image, did the appropriate updates etc...for a few months... then probably something I did broke the iptables... ...so I can start over (the equivalent

Hi Ed, Yes that is exactly right. Change 'ax25port=' to which ever port you will be using for Winlink messaging, then you will not have to bother with setting that argument on the command line.

If you use an NWDR SD card image and follow the "Getting Started" instructions then iptables will get installed properly. Along with iptables, the iptables-persistent package also gets

Ok, the iptable-up.sh does reinstall the iptables... ...but when I reboot, they get overwritten again... Now I have to figure out what is in the startup sequence that can over write the

Thank you, Basil, Does the /usr/local/etc/wl2k.conf need to stay as udr0 or can I change it since I am wanting to use udr1 for EMAIL and leave urd0 for APRS as the frequesncies are different? Ed,

Mike B <kf5dey@...> writes: Happy that's working for you. iptable-check.sh - Lists current iptables rules iptable-flush.sh - Clear all iptables rules iptable-up.sh - Add all iptables

Hi Ed, -a udr1 like this: wl2kax25 -a udr1 -c n7nix-10 You will be overriding whatever is in your /usr/local/etc/wl2k.conf configuration file. Take a look at the 'ax25port= ' line which should

I am now ready to move forward with sending email via wl2kax25. I just connected my second 2m rig to Port1.  Port0 is currently running XASTIR as a gateway. I am not getting the -a PORT part of the