Haven't seen this posted anywhere so I figured I'd ask here. I have a couple of large (200 GB) SDXC cards I could dedicate to this project. However, I read in the documentation that the minimum size

Today I did an apt-get update and apt-get upgrade and low and behold, the UDRC has returned. Bob AF9W pi@af9w-bpq:~ $ aplay -l **** List of PLAYBACK Hardware Devices **** card 0: udrc [udrc], device

Bryan, That’s the problem! Most of the critical lines are missing in that file. Mine reads: chip "ads1015-*" label in3 "User ADC Differential“ label in4 "+12V" label

Check This File carefully, the last line performs the 2X pi@K7UDR:~ $ cat /etc/sensors.d/draws #DRAWS uses the TL024 Which is SW Compatible with thw ADS1015 #It's an 8 Channel ADC, but only 4

Chuck and all: To receive a refund, send email to sales@... with REFUND as the subject. Include your order# and which items you wish to cancel. If you have a PayPal account include your PayPal email

Bryan and John, Essentially the same as yours Bryan! The one line different says: in5: +2.50 V Same as on the Dashboard. The very first thing I did when I re-checked it just now was to

Hi Bryan, How do I cancel an order for a case? I tried submitting a request via the proper contact web page but have not received a response in well over a month. I no longer have a need for the

Make sure you have an updated draws-manager (left menu) -- John D. Hays Kingston, WA K7VE

What does sensors report? pi@K7UDR:~ $ sensors rpi_volt-isa-0000 Adapter: ISA adapter in0: N/A ads1015-i2c-1-48 Adapter: bcm2835 I2C adapter +12V: +13.52 V +5V: +5.06

Bryan, That’s very interesting! Here is what the new board I just received is reporting: I see “in5: +2.50V” not “+5V: +5.06V” on that top line. Maybe I need to run an update of

Jack, I just ran DRAWS Manager with the updated config and it works fine.

Rebooting did the trick for sending. Now waiting for the return, peer to peer response. Ed, KD9FRQ

Thanks Bryan, Nothing to worry about then . . . hi hi. Cheers es 73, Daniel VE3NI / NI2D

This error message: connect(): Address already in use might indicate you have 2 instances of wl2kax25, wl2ktelnet or wl2kd running. It could happen if you had some hang or other problem that leaves

Following up............just did a quick retry........No Joy wl2kax25 -c WA9APQ connect(): Address already in use

OK. That is what I was using.  The ?? must have been added by the email program. Thanks, Ed, KD9FRQ

The correct syntax to send P2P is: wl2kax25 -c WA9APQ without the question marks! This syntax sends to the RMS Gateway which it looks like you can't connect with: wl2kax25 -c WA9APQ-10 Hearing a

Send me the contents of the listen command for the complete session. Ed Bloom, KD9FRQ via groups.io <ewbloom@...> writes:

Send me the contents of your /etc/ax25/ax25d.conf file. Ed Bloom, KD9FRQ via groups.io <ewbloom@...> writes:

Early adopter cards don’t have the 5V monitor capability