Also, once I've run the config script, where do you go to add the addresses after the fact? Assuming that I'm missing where to find this information, I'd be completely fine with a polite instruction

I will paraphrase...but essentially it says if you know you have to put something there then put it in, other wise just press enter to use the default. So in your case, I would just use the

I'm gonna have a million questions, I apologize right up front for that. I will stipulate to ignorance, no question about it. Just help me to understand, and when the light bulb finally comes on

Charlie, I am at the almost there point. Our statewide packet network is based on BPQ. There are various documents on the "internet" that describe the installation of LINBPQ using DIREWOLF with takes

Bumping this up to see if it gets any attention. I'm wanting to try BPQ32 with the DRAWS card and Direwolf - anyone been through this already? Charlie

Thanks Basil! I decided to order a couple of 32Gb cards just to be safe. Charlie

RPI 3 B vs SDXC https://www.raspberrypi.org/forums/viewtopic.php?t=155103#:~:text=The%20Pi%20has%20no%20problem,FAT32%20for%20Nobs%20to%20work. SD, SDHC,

Haven't seen this posted anywhere so I figured I'd ask here. I have a couple of large (200 GB) SDXC cards I could dedicate to this project. However, I read in the documentation that the minimum size

Today I did an apt-get update and apt-get upgrade and low and behold, the UDRC has returned. Bob AF9W pi@af9w-bpq:~ $ aplay -l **** List of PLAYBACK Hardware Devices **** card 0: udrc [udrc], device

Bryan, That’s the problem! Most of the critical lines are missing in that file. Mine reads: chip "ads1015-*" label in3 "User ADC Differential“ label in4 "+12V" label

Check This File carefully, the last line performs the 2X pi@K7UDR:~ $ cat /etc/sensors.d/draws #DRAWS uses the TL024 Which is SW Compatible with thw ADS1015 #It's an 8 Channel ADC, but only 4

Chuck and all: To receive a refund, send email to sales@... with REFUND as the subject. Include your order# and which items you wish to cancel. If you have a PayPal account include your PayPal email

Bryan and John, Essentially the same as yours Bryan! The one line different says: in5: +2.50 V Same as on the Dashboard. The very first thing I did when I re-checked it just now was to

Hi Bryan, How do I cancel an order for a case? I tried submitting a request via the proper contact web page but have not received a response in well over a month. I no longer have a need for the

Make sure you have an updated draws-manager (left menu) -- John D. Hays Kingston, WA K7VE

What does sensors report? pi@K7UDR:~ $ sensors rpi_volt-isa-0000 Adapter: ISA adapter in0: N/A ads1015-i2c-1-48 Adapter: bcm2835 I2C adapter +12V: +13.52 V +5V: +5.06

Bryan, That’s very interesting! Here is what the new board I just received is reporting: I see “in5: +2.50V” not “+5V: +5.06V” on that top line. Maybe I need to run an update of

Jack, I just ran DRAWS Manager with the updated config and it works fine.

Rebooting did the trick for sending. Now waiting for the return, peer to peer response. Ed, KD9FRQ

Thanks Bryan, Nothing to worry about then . . . hi hi. Cheers es 73, Daniel VE3NI / NI2D