Rich KR4PI <rich.schnieders@...> wrote: This error happens because the kernel is no longer able to talk to the codec on the I2C bus. I have seen this happen in software in a particular

Thanks for the assistance. I created a new sd card with a clean install and it worked without issue. I put the old sd card in and direwold had no packet tx audio. The following is the result of sudo

After install on clean new sd card I installed the updated dstarrepeater dstarrepeaterd and could not find UDRC controller configuration option 5 in the gui configurator and t was not obvious in the

Did you do a sudo apt-get update sudo apt-get upgrade ? -- John D. Hays K7VE PO Box 1223, Edmonds, WA 98020-1223

Hi Rich, From `dstarrepeaterconfig 1`...

Yes Sir. But I think my gui pulls and older version. I will try again. my gui still shows a may date. Thanks Rich KR4PI

If you're using the GUI, you may wish to install the GUI (Synaptic) package manager if you haven't already... sudo apt-get install synaptic

Can someone please put together a step by step instruction SET so people with limited Linux knowledge can get their systems up and running That I am sure would be a tremendous help Thanks Larry

Larry Could you be more specific. The wiki instructions provide basic setup. Where are you having a problem?

I was considering putting a UDRC installation guide together once the "dust settled", but in the meantime, as John had asked, how far along are you with the installation Larry, and what radios are you

Hello all, yes a complete guide would be of immense help with the install for those of us with limited Linux experience.

OK I have completed a new clean install and have discovered the following issues: 1. attempting to install direwolf via sudo apt-get install direwolf. Even after sudo apt-get update & sudo apt-get

OK I finally figured out how to load the gui dstarrepeaterconfig and ircddbgatewayconfig and have been able to get traffic to flow from my handheld through the FTM-100D through the UDRC to the

Hi Rich, The "poor man's" approach to getting this working. (Without a deviation meter and spectrum analyzer.) Use a second FM receiver and listen to the transmissions. You should hear modem tones on

On YouTube By Jeremy McDermond NH6Z -- John D. Hays Director PO Box 1223, Edmonds, WA 98020-1223

OK I have gone through the process you recommended John, but still cannot get the UDRC to transmit dstar data or voice. I hear no tones at all listing on an open fm receiver. I raised both PCM and LO

Hi Rich, While I haven't tried using the UDRC as a simplex hotspot yet, I did look over your dstarrepeaterconfig_1 file and noted that it contains a lot less lines than mine does. I've listed a few

I am trying to get the UDRC running as a hotspot. I don't have a monitor or keyboard for the Pi so I am attempting to do it headless (which I have don before with VK4TUX Fedora image). I can't seem

Assuming that it is the same as the one in DL5DI's package, the command line configuration program is /usr/bin/ircddbgw_conf. Bob, N7XY

Yes, that is where it is supposed to be but it is not there. It’s also not on the latest DStar Commander 2.00 package. I’ll try booting up one of my old images and getting it from there.