GPIO26 Is Connected to CODEC MP5 I don’t believe that it's used by the CODEC, so it should be available. We’ll confirm with SW Engineering. Bryan K7UDR

Thanks for hearing all of us. Wouldn't it have been easier to have remembered that early adopters were promised not only that a case would be available but that we'd get to pre-order it at a

John, Thank you for looking into this issue. I can appreciate the challenge the case presented with respect to the orientation of the SMA connector on the early adopter board and in the long

We hear you. Standby while we work out doing a special, one time, run for existing boards. Once engineering works out the design issue, we will need to take orders to get a count of how many to

Isn't it possible to use both audio devices at the same time? Reboot?? - Is this running windows?

Before I ran into DRAWS on the NWDigital website, I was already using a Raspberry Pi for my ThumbDV. I found this lovely device that I always intended to put on my Raspberry Pi, but never did. Now

Could try this: http://alchemy-power.com/pi-uptime-ups/ I think you can make a script that will safe shutdown on power loss. I would also check into making sure GPIO 26 is free, that's where the UPS

Being an early customer of draws I was expecting to purchase the aluminum case when it came out, now finding out you abandon us I have a diminished respect for your company. This is no way to treat

Look for something like a battery isolator to put between the RPi/DRAWS and the vehicle battery. West Mountain Radio makes one called ISOpwr but it’s a bit pricy. This setup should allow for

Yes, remember that us early adopters were told that we'd get a discount on an early purchase of the aluminum case. Not so I see... August KG7BZ

I saw the DRAWS board in the Aluminum Case at the Orlando Hamfest and ordered a board with the expectation of being able to get the case when it became available (I was specifically told the case

Me too. Perhaps you’d allow us to exchange the old board for a new one when we purchase a case? —Lor W3QA

I would like to know this too. I bought a DRAWS within minutes of the early announcement and have been waiting to buy an Aluminum case for months and now I find that this wait was worthless. August

I’m in the same boat as Ed. Really wanted a metal case to cut out RFI and I know one other who was waiting for the metal case to come out and then we see Acrylic version posted yesterday via

Are any of the first run aluminum DRAWS available for purchase? I would like to get two rather than the acrylic version.

great work Todd on figuring this out. I was able to create the script and I can now transmit with the draws on my OG IC-706 Thanks for all the legwork. Josh KB6FJ

The DRAWS™ HAT and built-in Raspberry Pi audio CODECS are separate. Edit /boot/config.txt and uncomment (near the end) dtparam=audio=on Save and reboot. This will activate the Raspberry Pi's

While not doing amateur digital, is there a way to switch audio from the hat, to using hdmi port through the speaker on the tv that I am using? I have tried with the draws hat on and off the board.

k7udr posted: "We have now opened orders for:DRAWS Kit $199.95For the Do-It-Your Selfer who wants to save money by doing the “Box Build” and SW Integration: DRAWS HAT GPS Antenna with LNA 2

Anyone automatically powering up/down (if that's possible) based on the 12v input sensor? I'd like to have my pi sleep or power off at a configurable voltage so that it will never run the car battery