Hi Michael, I’ve been away for a bit but I’m back in the lab. What you are seeing is the CODEC Turning on and the DC Bias charging up the coupling Cap. At this point yes you should see a sine

Replying to my own thread here, since I seem to be without any progress. I’m beginning to think I might have been sold a defective DRAWS Hat. When I execute the command: ./measure_deviate.sh -c

That would be VERY helpful.

Hi Jim, You bought the kit and haven’t received the backordered case, We’ve refunded the difference. Thanks, Bryan K7UDR

I have a DRAWS Pi HAT for sale. Included is the GPS module but no 6 pin to 6 pin DIN cable. All work but I have lost interest in it. I paid $200 for it and am asking $100 - a real steal ! First

Hello Basil, I tried running the test. It seems left or right channel still does not have a signal. Being that the Raspberry Pi has at least two sound drivers on it, I made sure that the UDRC

To rule out left/right port connector problems: https://github.com/nwdigitalradio/n7nix/tree/master/deviation Use n7nix/deviation/measure_deviate.sh This script will put a tone on either left or

Larry, Yes. Good assumption. In the near future you will be able to more easily control each port ie. on/off 1200/9600 baud. /Basil n7nix

Hadn't looked into it before. I am now, as of 30 minutes ago, install script worked fine, status looked good, UHF/VHF radios work great, will test HF when I get an antenna back up. Ran

Four points follow. First, I am not a gui-guy in the least, so feel free to disregard anything I have to say about this. Hoop, K9QJS, made an attractive icon & I took my lead from him. He is a

Works for me this way, too. Used regularly. 73 Hoop, K9QJS

My two cents on this. I would disagree. I feel that the icon should represent what the icon is going to do. So if it has an X on it, that means it’s going to to stop AX25. If it doesn’t have

Thank you for the reply Basil, Just to be fair, I did a fresh install, and I still have the same results. I also have no audio of any kind coming from pin 1. My 'scope shows nothing, but

Hello, I've asked, end of last year, for a cancellation of the case order I did. I've never had any news. Now that the case is produced, will i get one or will i be reimbursed ? I understand you have

Hi Basil, I seem to concur with J P Watters as it is a bit counter intuitive. For those that don't run headless, it seems it would be better in the GUI for the icon to indicate the current state of

Provide the console output of: udrcver.sh alsa-show.sh aplay -l You should be routing AFOUT which will be IN2 R:[10 kOhm] Make sure squelch is low or off. What sound card device are you using for in

Hello all, I am beta-testing a new cable from HamMadeParts. I have the cable connected from the DRAWs Hat to the G90 ACC port. After some considerable configuration, I finally got it mostly working.

Very Good. Was able to install what I needed. That fixed it. Not sure what I did to cause the file corruption, but dpkg behaves itself now. Back to "prime time". Much obliged. -- Jack - KD4IZ

OK... that seemed to do something: Console output: pi@kd4izdraws2:~ $ dpkg -l "rpi-eeprom*" Desired=Unknown/Install/Remove/Purge/Hold |

Jack, Not sure if this worked or not. Guessing it didn't. Some files in your file system are corrupted. As a last attempt do this: dpkg -l "rpi-eeprom*" # Note asterisk at end of rpi-eeprom sudo