I'm interested in using DRAWS to drive my FT-818ND for digital applications up in the microwave bands Eg. 904, 1296, 2304 MHz, etc (FT8, JS8CALL, etc) as well as a precise frequency reference for my

Ed Bloom, KD9FRQ via Groups.Io <ewbloom@...> writes: DRAWS Compass refers to the current and now deprecated image. That image does not have piardopc installed. The next image most

AH...........Yes, KM4ACK............. Coffee had not kicked in yet.................... Ed Bloom, KD9FRQ ewbloom@... Sent from Webmail access

Hey Ed! I believe you're referring to the excellent YouTube videos from KM4ACK. I can't speak to what might have already been installed on the DRAWS Compass image in regard to ARDOP... all I did was

As a followup to setting up PAT with the DRAWS.... Is the ARDOP install that comes with teh DRAWS Compass package "installed" and available to PAT once PAT is installed? I ask because I see ARDOP

Thanks for the update! Could this explain why my recent DRAWs board (2 weeks old) doesn't work at all with the default TM-V71A alsa settings that ship with your image ? I mean the

We have discovered that a capacitor was installed in the audio filter chain that can prevent certain applications from functioning properly. We apologize that this was not detected before the boards

https://www.maketecheasier.com/create-desktop-file-linux/ (Step 5 forward) -- John D. Hays Kingston, WA K7VE

John, Ah!!!?? Good to know.?? I will shut it down. Thank you. Regards, Ed

Basil, Thank you. I do not know enough about networking to know I could actually do that. Regards, Ed

Scott, Thank you. That is what I was going to do next. But was not 100% sure. So I stopped and asked the question. Networking is not my IT strong suit. I am an application

DRAWS™ Manager does not need to run all of the time. It is a setup tool, then you can shut it down. sudo systemctl stop draws-manager and to prevent it starting up on next reboot sudo systemctl

Hi Ed! There are two issues to take care of here. As was mentioned, 0.0.0.0 is not the address for you to use. When you are accessing a web page on the same machine you are using, the "loopback" or

Ed, IP address 0.0.0.0 is a "special IP address" for defining an unknown or invalid target OR all IPV4 addresses on all interfaces on the local machine. Why don't you use some non-routable address

KM4ACK, Do you have any suggestions on the IP Address for PAT with the DRAWS. When I enter 0.0.0.0 I get an error when starting PAT (address already in use). When I enter

DRAWS™ CODEC is available under ALSA (and pulseaudio), anyone who wants to try this should look at chan_alsa and app_rpt Can app_rpt do PTT and SQUELCH DETECT using Raspberry Pi GPIO pins? -- John

I have had success sending and receiving on the 891 without removing pin 6.

Hi Tom, I have the gps working and I don't have the battery installed Regards Jonathan GI7KMC

Silly me. I thought I only needed to install the CR1220 if I wanted the RTC to continue to operate while the power was off. Apparently, the battery has to be installed for the GPS to operate. The GPS

Thank you!!! I am interested in ARDOP via HF and ax25 on 2m.