Scott, Thank you. That is what I was going to do next. But was not 100% sure. So I stopped and asked the question. Networking is not my IT strong suit. I am an application

DRAWS™ Manager does not need to run all of the time. It is a setup tool, then you can shut it down. sudo systemctl stop draws-manager and to prevent it starting up on next reboot sudo systemctl

Hi Ed! There are two issues to take care of here. As was mentioned, 0.0.0.0 is not the address for you to use. When you are accessing a web page on the same machine you are using, the "loopback" or

Ed, IP address 0.0.0.0 is a "special IP address" for defining an unknown or invalid target OR all IPV4 addresses on all interfaces on the local machine. Why don't you use some non-routable address

KM4ACK, Do you have any suggestions on the IP Address for PAT with the DRAWS. When I enter 0.0.0.0 I get an error when starting PAT (address already in use). When I enter

DRAWS™ CODEC is available under ALSA (and pulseaudio), anyone who wants to try this should look at chan_alsa and app_rpt Can app_rpt do PTT and SQUELCH DETECT using Raspberry Pi GPIO pins? -- John

I have had success sending and receiving on the 891 without removing pin 6.

Hi Tom, I have the gps working and I don't have the battery installed Regards Jonathan GI7KMC

Silly me. I thought I only needed to install the CR1220 if I wanted the RTC to continue to operate while the power was off. Apparently, the battery has to be installed for the GPS to operate. The GPS

Thank you!!! I am interested in ARDOP via HF and ax25 on 2m.

Hi Ed! PAT works extremely well on the Pi/DRAWS using telnet, ax25, & ARDOP. The following video walks through the setup and there are many others from the same author going in to more detail on

If the antenna has a good view of the sky, the first startup can take a while. You can also restart the gpsd sudo systemctl stop gpsd sudo systemctl start gpsd You can also stop gpsd and. cat

Please don't take this wrong but have you hooked up an antenna to the draw hat gps connector?

I just received my DRAWS and at this point in time, I am only interested in getting the GPS working. (I'm developing a new ThumbDV app for D-Star Routing and linking and want to use the GPS to update

Has anyone setup PAT via DRAWS??? I have not seen this but admit I may have missed it. 73s, Ed, KD9FRQ

thanks! I'll double check and see what I'm doing wrong that it's not loading the driver.

Do we need to remove pin 6 for FT-891s?

The current (Buster) Raspbian has the driver built in. You don't need the DKMS for it.

I've been looking around the site and I see mention of a udrc-dkms (I'm assuming thats the audio driver file for the udrc) my question is there a repository somewhere that I could add to, say,

I was not upset about your responses I did every thing you said it was the lack of response from the office, and I think maybe they should offer to test some of the unit people cant get the unit to