I'm not sure if it's included, but there is an open source implementation of ARDOP that can be compiled to run natively on the Pi. Check here:

I've only had my DRAWS board for a day, but did have success running the PAT Winlink client (thanks to the YouTube videos by KM4ACK) over 2m ax25 packet. I will get around to testing the HF modes but

Is anyone using the DRAWS Pi HAT for HF email that would be similar to ARDOP (part of WinLink) or WinMor (also part of WinLink) that both run under Windows? I'm using an FT857D, a Pi 3B+, a DRAWS

Over the air testing revealed that what I was seeing here is mirrored over 200 miles away, so it is not likely a local RFI issue on RX here. Then, I hooked up an external high quality sound card via

Well, I tried it at first with my FT-897D, got no audio, then tried switching to an Icom IC-706MkIIG… still no joy. I was using arecord/aplay and netcat for testing. I have a Pi 3 with a UDRC-II

Describe your problem and answer these questions: as in prev message Did you make your own cables? No, using cables provided with the DRAWS Which mDin6 connector are you using? Looking at the front

DRAWS image Beta13 I am getting output audio which undulates when using either FLDIGI or JS8Call (or even when just using the TUNE button in FLDIGI). Has anyone run across this? My draws-manager has

I am not where I can look right now, but seem to recall WSJT (FT8) does not implement GPIO PTT, so you have to use CAT through hamlib or VOX. Fldigi has a setting for GPIO PTT on a tab beyond the CAT

Does the RED Led light?

I am using DRAWS software version "DRAWS_BETA13" from May 7, 2019. I connected to DRAWS MANAGER and set the receive & transmit levels there. I am using a single 6 pin miniDIN cable plugged into the

The software I plan to use requires the SQL signal to key up PTT in a VoIP application. As stated in my original email: In short, I'll be doing FM and SSB voice via the DRAWS board. I'll have a

It works. Just as you said it would. And I had a ton of fun getting it there. Thanks, Alan . KJ7BFC

Was working normally for months then audio out stopped including echo. Alsamixer settings appear normal.

No, because it doesn’t have the IO Configuration and connector. What failed? Bryan

I guess the question I should have asked was can a DRAWS be used to replace a failed UDRC2 on a DR1X

The DRAWS should supply voltage to the pi if your supplying 12v to the DRAWS unit input power. Dont power Pi separately

Make sure it’s on the header correctly and check the 5V Pin on the Pi Header

I connected the Draws to my 12v battery box and nothing happens. It boots normally, when I supply power to the Pi. Are there troubleshooting instructions? Thanks, Stuart, K2YYY

Squelch in the Radio is for analog modes so we don’t annoy the humans. The SW Modem isn’t annoyed so I turn squelch off in the radio.

How do I read the state of the SQL pin if it's open-circuit? -- Stuart Longland (aka Redhatter, VK4MSL) I haven't lost my mind... ...it's backed up on a tape somewhere.