List of utilities to verify DRAWS gps device https://github.com/nwdigitalradio/n7nix/blob/master/docs/VERIFY_CONFIG.md#check-gps /Basil n7nix Ryan Matthew Headley <headley.ryan@gmail.com> writes:

#draws #gps

The 1PPS Signal is on IO7, Pin 26 on the 40 pin header if you have an Oscillator with 1PPS Sync input. Bryan K7UDR

#1pps #frequencyreference #draws #gps #time

Cool! Like seeing results from the longer runs. Your results look good, or at least as good as I have seen on my units. So forgive me, I'm trying to remember if this run is without the gps battery ins

#gps

No worries -- a good data point!

#gpsd #gps

I was confused on the placement of the dtparam=audio=on statement in config.txt. It must come after the dtoverlay=draws statement as that loads the software that supports the audio. 73 Mike - KB0FX

#gps #gpsd

One and All, Thank you for the responses. I have found a solution. I will use bulk head pass throughs the concrete bunker walls (my small basement is an old Coal Bunker) I will use a short run of Sate

#gps

A friend of mine is running RG-6 for more than 80' to a similar GPS antenna - here are some adapters, if you want to try. https://www.amazon.com/exgoofit-F-Type-Coaxial-Adapter-Connector/dp/B07D28P28J

#gps

so try this: - unplug the antenna and lan cable - shutdown and unplug the pi for about 10-20 minutes or so (this gives you a good gap to check stuff) - start back up it should auto change the time (yo

#ntp #chrony #gps #clock #battery

We are using the S1216F8-GL Datasheet:

#draws #gps

I made those few changes and up and working great!!!

#draws #gpsd #gps #setup