thanks! I'll double check and see what I'm doing wrong that it's not loading the driver.

#audio #draws #udrc-ii #documentation

The current (Buster) Raspbian has the driver built in. You don't need the DKMS for it.

#audio #draws #udrc-ii #documentation

I've been looking around the site and I see mention of a udrc-dkms (I'm assuming thats the audio driver file for the udrc) my question is there a repository somewhere that I could add to, say, raspbia

#audio #draws #udrc-ii #documentation

Basil, thank you very much for your reply. I will try with XASTIR. I was not successful with APRSICE32. 73 de TG9AOR

#udrc-ii #direwolf

TG9AOR <qrz@tg9aor.net> writes: The port selection for AGWPE could be different depending on the application you are configuring. ie. Xastir uses AGWPE transmit radioport 1,2 that corresponds with dir

#udrc-ii #direwolf

Good morning. Did I post this question in the wrong forum? Is there not a way to change the way direwolf uses the HD-15 connector instead of the miniDIN connector for AGW packet engine use on the UDRC

#udrc-ii #direwolf

Hello all. I am using APRSISCE/32 and whenever I want to send a message, either using KISS or AGW connections, direwolf sends it via channel 0. I do not have a radio connected to and do not plan to us

#udrc-ii #direwolf

Thanks Steve, this has been sold.

#udrc-ii

Ok, my email on QRZ is good. Art

#udrc-ii

Art: I’ll take it. Not a member of QRZ. Will email you directly soon - in the middle of of a event and had a few minutes on my phone.

#udrc-ii

Hi Folks, I have a UDRC-II complete repeater setup for DR1X , plug and play setup with cable, reaspberry Pi, D-star reapeater image etc. $125 shipped US priority mail. I have it on QRZ right now: http

#udrc-ii

Hi, I wanted to see if anyone else has run into this issue with virtual ALSA devices and Direwolf. I'm aware that virtual devices are experimental, and my config works properly when using the hardware

#udrc-ii

I will give that a check soon. Thanks!

#udrc-ii

I can verify that the non-refurbed DR1-Xs both 1.0x and 1.10x firmware work with proper d-star audio levels with UDRC-II with firmware in the past 18 months. I have been told that the 9600 baud option

#udrc-ii

We don't know for sure, but we think that the refurbs are actively trying to block any external modem. The original should have worked, if the directions were carefully followed (with no internal modi

#udrc-ii

It is a refurb, but I don't recall the firmware version off the top of my head. We also tried it with the non-refurb DR1X that we have, and had the same TX audio issue. The levels would just never com

#udrc-ii

Is the DR-1X a newer referb? What firmware does it have?

#udrc-ii

I am attempting to make a straight through custom cable that breaks out the PTT and Audio Out lines. I have performed the modification to the DR1-X cable that connects the receiver and transmitter so

#udrc-ii

The UDRC/UDRC-II 15-PIN connector is aligned to connect to the DR-1X HD-15 connector using a straight through 15 line cable. This was created to be a plug to plug connection. We are not sure that refu

#udrc-ii

I have a question about the pinout shown in the wiring diagram. Is this shown from the rear, or from the front, like you were looking at the connector face? The pin orientation is off from that of the

#udrc-ii