I did the measurements John recommemded The first step is to make sure you are decoding. Run a tail -f /var/log/opendv/dstarstarrepeaterd_1.log in a terminal and restart dstarrepeaterd by issuing: pi@

Thanks Jeremy Bill

What is the best way to install timeserver and have it start automatically? Thanks Bill

OK thanks, I'll try that. Bill

I could see it at hw0:0 in the configuration. I had stopped dstarrepeaterd while I made the change to /boot/config.txt, then restarted dstarrepeaterd and got this: E: 2016-06-19 15:49:34: Cannot open

Could it be because the UDRC steps up to the card 0: position when the BCM audio device is removed? Then here is the log file. dstarrepeater was working then I commented out the BCM device and restart

dstarrepeaterd doesn't seem to want to start when I comment dtparam=audio=on out. Is there something else to do? Bill

I went back and disabled the command to automatically start dstarrepeaterd and I was able to pick the UDRC. I stopped dstarrepeaterd, executed curl -L -s https://goo.gl/h04nla | sudo sh and ran the co

Thanks for looking at this Jeremy

The YouTube tutorial for the DR-1x is great! Thanks. I followed it and got dstarrepeater working. At the point in the tutorial that you check for updates, my Pi found 50 updates and I applied them. I

I hooked up my UDRC and it works fine in analog and Fusion. I am not getting repeater dstar data transmit from the DR-1x repeater. The repeater keys up with a dead carrier. The dstarrepeater GUI decod

I've hooked up my new UDRC. In Dstar mode the DR-1x hears the input signal and keys the transmitter but there is now data modulation. The Dstarrepeater GUI decodes my handheld fine just no tx data fro