Sounds like a good application for some of the economic impact stimulus funds... Bill

Which would be helpful if you were doing 9600 baud packet or higher bandwidth voice modulations. Probably not an issue on the HF 7300 like it is on the all-band all-mode IC-7100.

I've seen issues arise when using both synaptic and command line apt-get. Be careful and watch for weirdness.

How about running two instances of Direwolf?

And you can install either LinBPQ or JNOS to do packet without the complexity of dealing with the Linux AX.25 stack. (Not saying that LinBPQ or JNOS are less complex....) Bill

Is this carefully explained somewhere? It seems a bit weird to have to pull a pin from a data cable. (Or is it like the rPI 4 charging cables...) Bill

Does DRAWS work with the Atomic pi? Awesome SBC, reasonable price and runs Windows since it's based on the Intel Atom SOC...

I've finally learned to use the print to PDF option in the browsers. The markdown docs look great when saved that way...

Isn't it possible to use both audio devices at the same time? Reboot?? - Is this running windows?

Perhaps this widget from the BPQ software collection will help out. I have to use it with the IC-7100 to do packet. http://www.cantab.net/users/john.wiseman/Documents/CAT7200.html

#wsjtx #hamlib #icom #flrig #kx3

Nobody is using PAT? It should run on DRAWS as a client.

That sounds like you are transmitting at 9600 baud. Is that intentional? A brief burst of static is what you'll hear. Bill

#direwolf #draws #xastir

>> ... And encourage the NWDR folks to add the 3 or so resistors needed to DRAWS on the next rev so it will also have the CTT/CI-V cable functionality. Bill, wa7nwp

From a Mar 17, 2018 posting to the wetnet list:

Check the email threads about the time the 3b+ came out. You have to update all the way on the 3b before it will work on the 3b+. Best just to start with a new image - IMHO.

That's a good question and even after all these years that's still the big problem. While there are some good'ish radios they are expensive and which they are is not well defined. It also depends on w

So they are working fine with the 9600 baud APRS channels? That should allow you to get receive working - at least of short APRS packets. Getting long APRS status packets with long paths would be a se

How does the receiving work comparing locally transmitted packets versus all the 9k6 APRS activity? (440.800, 144.350, 145.550, 223.600) Any chance overload could be an issue if the two radios are ver

... and modify the docs/wiki if there are different better easier ways to get the systems up and running... Bill

Direwolf has DTMF functionality so it shouldn't be too hard to the pieces together.