Date
1 - 6 of 6
Setting up your DRAWS™ GPS #draws #setup #gpsd #gps
|
I made those few changes and up and working great!!!
|
|
|
|
Brian Badger
gpsd is up. Thank you for adding this to the wiki so quickly.
toggle quoted messageShow quoted text
— Brian N0KZ
On Nov 29, 2018, at 12:15 PM, John D Hays - K7VE <john@...> wrote:
|
|
|
|
I updated the Wiki page to note this requirement.
On Thu, Nov 29, 2018 at 11:11 AM John D. Hays <john@...> wrote:
--
John D. Hays Edmonds, WA K7VE   
|
|
|
|
There is no separate GPS driver. If you are not seeing /dev/ttySC0 then check the last line of /boot/config.txt and make sure it indicates draws instead of udrc. If you need to change it, you will need to reboot for it to take effect. "edit /boot/config.txt and change the last line from dtoverlay=udrc to dtoverlay=draws" -- from https://nw-digital-radio.groups.io/g/udrc/message/2023
On Thu, Nov 29, 2018 at 11:03 AM Brian Badger <brian@...> wrote:
--
John D. Hays Edmonds, WA K7VE
|
|
|
|
Brian Badger
Ensure that the device tree and driver have been installed on your Raspberry Pi image. There should be a filename of /dev/ttySC0, which is the serial port for the GPS receiver and /dev/pps0, which is the pulse per second port from the receiver. If these files are not visible, then review your operating system (Compass Linux or Raspbian with updates) install. What is the gps kernel module I should be looking for? — Brian N0KZ
|
|
|
|
https://nw-digital-radio.groups.io/g/udrc/wiki/DRAWS%E2%84%A2%3A-Setup-GPSD-for-Time-and--Position
|
|
|