YAAC Port Settings #yaac #xastir
|
Tim Sperry
What are the proper port settings to use when setting up the DRAWS Hat with YAAC?
I have everything working fine between the DRAWS Hat and my FT-891 using WSJT-X and FLDIGI with AX25-stop Now I think I need to start AX25 to use YAAC or XASTIR Is there the needed information in this group to set up either or of these with the Hat? Tim - AG6RS
|
|
|
|
I have some Xastir configuration notes here:
toggle quoted messageShow quoted text
https://github.com/nwdigitalradio/n7nix/tree/master/xastir The "Configure interfaces" section will be useful for you. These notes were written for a UDRC II but the BETA images have a lot of things already setup. If you are using a Beta image: - Latest version of Xastir (V2.1.1) is already installed - RPi audio is already enabled - Xastir sounds are already downloaded - Direwolf is already configured. You should be able to run it and start configuration. The Xastir documentation is very good: https://xastir.org/index.php/Main_Page I do not have any notes on YAAC which means I didn't have any problems with the initial configuration. Both programs require running ax25-start as root. This starts direwolf using systemd service files. You only have to do this once unless you run ax25-stop to facilitate running HF digital programs. /Basil n7nix Tim Sperry via Groups.Io <tsperry=verizon.net@groups.io> writes:
What are the proper port settings to use when setting up the DRAWS Hat with YAAC?
|
|
|
|
As Basil says, his AX25 scripts start and stop both the Direwolf modem and the AX25 stack. YAAC is pretty simple to connect. With direwolf running, you simply go into interfaces and select an AGW interface localhost:8000 You can watch what's happening using (in a terminal window) tail -f /var/log/direwolf/direwolf.conf
On Wed, May 8, 2019 at 8:48 AM Tim Sperry via Groups.Io <tsperry=verizon.net@groups.io> wrote: What are the proper port settings to use when setting up the DRAWS Hat with YAAC? --
John D. Hays Edmonds, WA K7VE   
|
|
|
|
Tim,
I do this all the time.
You should not need to touch your ALSAmixer sound settings.
You do need to go back to the “Getting Started Wiki” at Groups.io and carefully work through the section on using ax25/DireWolf. https://nw-digital-radio.groups.io/g/udrc/wiki/DRAWS%3A-Getting-Started
Two important points: When you want to switch to YAAC (or XASTIR) on DireWolf you need to open a terminal window and do the following as described in the “Getting Started Wiki”: cd ~/bin # Become root sudo su ./ax25-start
This will enable ax25 and Direwolf… Direwolf will continue to run on boot up so to go back to fldigi or wsjt-x, you need to do the following in a terminal window: cdcd bin# Become rootsudo su./ax25-stop
Hope this helps get you going the right direction.
KD4IZ Jack Spitznagel FM19oo
From: udrc@nw-digital-radio.groups.io <udrc@nw-digital-radio.groups.io> On Behalf Of Tim Sperry via Groups.Io
What are the proper port settings to use when setting up the DRAWS Hat with YAAC? -- J Spitznagel Science River LLC KD4IZ
|
|
|
|
AG6RS@...
Thank you all for the info
XASTIR is up an running Working on YAAC next Tim - AG6RS
|
|
|